1

I have a Cannondale MTB frame I'd like to make a cruzer by adding a Sturmey Archer 2-speed kick shift. The SA axel length is 162mm and the spacing is 116mm but the Cannondale spacing is 135mm (remember this is an aluminum frame so it's not flexible). This doesn't leave a lot of room for the nut!

In my mind as long as I can get the chain rings to line up and tighten the bolts I should be good!?

Improve this question
2
  • So if you were to mount this to a 135 mm rear dropout you'd need to fill in 9.5 mm on each side which would leave ~13.5 mm to protrude through the dropout and thread through the lock washer and nut...how thick are the lock washer and nut?
    – WTHarper
    Jun 24, 2013 at 21:27
  • Much better to find a longer axle for the hub if you can, then when you're installing it put proper spacers on the axle. With solid spacers I think you should be fine, but washers are not properly flat so will not give you enough rigidity. Viz, you might well bend the axle.
    – Móż
    Jun 25, 2013 at 3:46

1 Answer 1

Reset to default
1

Sheldon Brown has a good page on frame adjustment - I especially refer you to his instructions on aluminum (and carbon) frames - DON'T

As long as you can get the nuts on far enough that axle thread is visible, you will be OK, however, at 13mm for the frame, washer and nut, I will be surprised. You might be tempted to use a smaller spacer and compress the frame. I have no idea how much would be consider too much - 1, 2 5mm? I would have a guess 1 or 2 is fine, but 5 might be pushing it.

You should be able to get the chain line correct by changing spacers, however it might also mean redishing the wheel.

How do you plan to adjust the chain tension. Are the dropouts on the frame horizontal?

Improve this answer
1
  • The dropouts are vertical :( And yes, I would need to add a tensioner.
    – xtian
    Jun 29, 2013 at 15:44

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.