13

I'm building two new sets of mountain bike 26" wheels, and I'm wondering what to go with. Both are double walled rims, so in addition to the standard rim tape and strips, I can use a product like VeloPlugs.

Here's my current understanding:

VeloPlugs

VeloPlugs http://www.radfahren.de/typo3temp/pics/2378aa8792.jpg

  • Most expensive ($7 / wheel)
  • Reusable
  • Lightest (~5g)
  • Double Walled Rims only
  • Have to measure spoke holes in double wall (8mm vs 8.5-9.3mm)
  • May lose them when changing tubes, so carry extras on rides

Rim Strips

Rim Strip

  • Mid-range price ($4 / wheel)
  • Reusable

Rim Tape

Rim Tape

  • Cheapest (~$3 / wheel)
  • Won't slide around like Rim Strips
  • Weight (~20g)
  • Glue may prevent nipples from loosening in single walled rims
  • Won't slide around on rim
  • Most common / available

What are other points or guiding factors in selecting which to use? I'm not concerned with price and availability, I'll wait/pay for the best option. I'm leaning toward VeloPlugs for dual walled rims and rim tape for single walled.

Furthermore, if anyone has used VeloPlugs before, how do you find the diameter of the spoke holes when the rim manufacturers doesn't publish it? Just wait until the rims are in hand and measure with a caliper?

2
  • My preference has always been for rim tape, though no strong reason why, other than rim strips are not always available in the correct size. Apr 4, 2012 at 2:52
  • And you failed to mention hockey tape. Sep 26, 2015 at 1:57

11 Answers 11

5

I just recieved veloplugs today for the wheels i am building and i must say that i like the design and the fit. I measured the holes inside the rim and they were exactly 8mm so i went with the same 8mm model plugs. If you dont know yours you will definetley have to remove your tire and tube and peel back the tape to get a good measurement. I weighed the tape used on my old rims and it weighed 36 grams from both. I forget the exact math but it was almost a full 30 grams i would be saving on rotational wheel weight and the fit actually gives me confidence to go with a lighter tube due to less concern of pinching on install with rim tape.

7

There are advantages to all of them, but tape has always been my preference.

I've used velo plugs, but in my wheels the incidence of loss was too high. They lasted me less than a year, before I lost all the extras, and went back to tape.

I don't use rubber rim strips because the rubber degrades, and they move around too easily.

I prefer Schwalbe high pressure rim tape, because it gives a good seal, stays put, and sticks better than cloth tape like Velox, but still removes clean and easy when the time comes.

I hope that helps.

4
  • Did I miss any advantages/disadvantages? If I did, please add them to your answer. You only lost plugs while changing tubes, right? (FYI they claim to have addressed that issue in the newer versions, red being for 8mm holes and yellow for 8.5-9.3mm holes. However, the rims I'm buying don't state their hole diameter, nor do most rim specifications)
    – Ehryk
    Apr 4, 2012 at 6:24
  • No, you pretty much covered it, except for the glue residue from rim tape, and having to clean the rim to re-apply, and possibly the ease of install as a negative for Velox style rim tape. It's not difficult, but takes a bit of practice.
    – zenbike
    Apr 4, 2012 at 6:35
  • High pressure rim tape is elastic and doesn't have a sticky backing, right? If it's the stuff I'm thinking of, it's great and doesn't slide around like ordinary cloth rim tape can.
    – amcnabb
    Jan 19, 2014 at 19:21
  • No, Schwalbe's High pressure rim tape is a specific, sticky backed tape which has a soft plastic feel to it. It is not cloth, but is similar in application. Also the adhesive used, unlike velox tape, is very strong, and stays in place well.
    – zenbike
    Apr 15, 2016 at 18:27
6

When I bought the carbon 50mm wheels, I put on the yellow velo plugs. I had more plugs than necessary and I made sure the plugs fit snugly into each hole. Some plugs didn't. But I had enough plugs to choose from. Its been over 2 years and I have not experienced any loss of plugs. During those 2 years I had numerous punctures, front and rear and a change of tires as well.

3

You left out reinforced plastic/rubber type strips. Kore Chastity Belt strips are my favorite and rated for 140psi. Very durable. FSA, Origin8, etc also make this type, available in many common sizes. Price ranges from $2.50 - $4 each.

I do like cloth tape, but the adhesive can dry out (even before purchase). Velox is $5 a piece at my shop.

Rubber rim strips are junk in my opinion, definitely a last choice. They are commonly the cheapest and sell for $1 each at my shop.

I've not heard anything bad about Veloplugs.

2

Tire manufacturers recommend to change the rim tape each time you change a tire.

Plastic rim tapes actually get damaged after a few thousands km under high pressure and I hate rim cloth that get soaked with water under rain. I have been using veloplugs for a year now and I am very happy with this system.

Easy to install, light weight, and above all very safe. Also makes tire mounting much easier. Just remember to put a few spares in your saddle bag when you ride, in case you loose one when fixing a flat on the side of the road

2
  • 1
    @andy256 what's with all the edits to americanize spellings? Changing tyre to tire makes zero difference to the meaning. All it does is wake up old threads.
    – Criggie
    Sep 30, 2015 at 0:17
  • 3
    @Criggie Ah, so you haven't seen the review queue? In this case, the motivation was the caps and formatting. Tyre / tire was just collateral :-) Regarding waking old threads, It's actually encouraged by about five different badges.
    – andy256
    Sep 30, 2015 at 0:32
1

Rim tape can actually slip, slowly, due to heat and/or mechanical stresses (rolling of the wheel, twisted tube), but would be my choice, since they're not elastic (accept high pressures well) and can't damage the tubes.

Rim strips are very fine, but their edges might become hard with aging, and I have had some flats due to cuts in the innertubes caused by these edges.

Have never used plugs (actually didn't know they existed), so cannot tell about them.

2
  • Rim tape can slip, but if you use high quality tape, as linked in my answer, it doesn't.
    – zenbike
    Apr 4, 2012 at 5:19
  • 1
    Fortunately I have a nearby Schwalbe supplier, gonna get some, thanks! Apr 4, 2012 at 12:39
1

I use the veloplugs, but for touring and commuting I put a strip of vinyl electrical tape over the top of them so I don't lose plugs when changing tires. On a low pressure tire I don't have a big preference.

1
  • 2
    Welcome to Bicycles SE. This answer would be better if you explained the reasoning behind your preference for velo plugs, as well as the reason that you have less of a preference for low pressure tires.
    – jimchristie
    Mar 29, 2014 at 18:32
0

Or you can use cheap plastic adhesive tape, usually two to five layers. It's cheaper and lighter than any of the above, but it doesn't last especially long. It helps if you de-burr and round off the edges of the spoke holes. After a while you will start getting punctures where the tape has given way and the tube gets cut by the spoke holes. I was surprised to find that even two layers worked in MTB tyres at ~60psi. When every gram counts this is what I've done. It also works as a desperate measure when you fix a flat and the existing fix is damaged.

Rim tape also comes in plastic variants that are lighter, last longer and cost more than rubber ones. Often with tapered edges (you really only need it to cover the spoke holes), but they're still heaver than rim tape and costs more.

In real life (rather than for one race) I use rim tape. It's cheap, easy to get, lasts ages and it works.

1
  • 2
    Not durable enough to do the job of rim tape. And as you noted, it degrades too fast, even if you layer it up enough to protect your tubes. Also leaves a weird, slimy, sticky residue behind when it is removed, and doesn't stay in place well either.
    – zenbike
    Apr 4, 2012 at 5:17
0

Gorilla tape, cutting one half inch strip patch for each spoke? And then a rim strip or old inner tube made into a rim strip over that?

1
  • 1
    Welcome to stackexchange. It's not a discussion format but rather a question and answer format, so answering with questions isn't really an answer. Reviewing the FAQ would probably be helpful. Apr 13, 2013 at 22:36
0

3M duct tape, 3 layers at least (cut to fit). Alternative: 3M super 88 electrical tape. Again layers of it. These are just poor mans solution in an isolated place but with a hardware store around. If you have good LBS stores nearby, get the best recommended.

0

Velox. If you can't get it, go to medical supply store and get COTTON bandage tape; you'll have to cot your own valve stem hole.

Veloplugs are lighter weight. Good for race setup.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.