Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

Hoping you guys could help me. I recently bought SPD cleats and as mentioned in this forum I've been using spinning bikes to practice unclipping.

I've noticed that my right shoe is getting damaged with the cleat. As in it is grinding into the sole of the shoe and scraping it. I am having difficulty unclipping this shoe.

Strange thin is I'm not having this issue with the left shoe. Ive tried various spinning bikes and I have the same problem.

I'm afrain I'm going to grind a hole into my sole.

Please help. :-(

share|improve this question
1  
To verify: You are using shoes intended for SPD cleats, right? And when you installed the cleats you properly re-inserted the shoe sole insert (if there was one)? And the cleats are tight and aligned the same on both shoes? Could you have cross-threaded the bolts, or bent the mounting plate? –  Daniel R Hicks Jul 16 '12 at 11:46

2 Answers 2

Just to give you an update.

@daniel... I went back to the shop where i had bought the shoes from. The cleat on the right shoe had been put on the back set of holes. The left foot had been on the front set of holes.

So they adjusted them for me. And its clipping out quie easily now. Thanks for all your help and to all of those who responded. You guys rock!

Happy riding!

share|improve this answer
    
You might consider adding this information as a comment instead of as an answer. –  amcnabb Jul 19 '12 at 15:00

Most probably you have not screwed it in tight enough. Cleats have to be screwed to the sole really tight.

Because the cleat is so small compared to your leg, there is a huge leverage being applied to it when clipping in/unclipping. If it's not tight enough, that's just what you can expect - it will move against the sole at pressure and grind it down.

share|improve this answer
    
Hi @Ttarchala, I'm fairly sure that is not the reason, I've really tightened them, If anything I was afraid I had overdone the tightening. –  Dipen P Jul 16 '12 at 9:53
1  
The cleats really do need to be tight and dig in to the shoe, are you sure they were installed properly? Are the teethy sides of the cleats touching the shoe and not facing away? Here are some good install instructions. drivemybike.wordpress.com/2009/05/23/… –  Benzo Jul 16 '12 at 12:45

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.