Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I want change the groupset on my Scott Addict R2 from Shimano to Campagnolo. Is Campagnolo fully compatible or will I need to make frame changes?

share|improve this question

4 Answers 4

As your Scott is a modern bike, I'd be inclined to agree with some of the other answers here and say that I don't think you will require any modifications to your frame if you switch from Shimano to Campagnolo. There are some areas which are not strictly frame related where you may need to be careful.

If you're switching to an EPS groupset then it's likely that your frame won't have specific mounts or routing for the electronic cabling. However, in my experience you've often got options to run the cables externally quite neatly.

As already mentioned, you will need to either change your wheels (or the freehub body if possible on your current set) so that they can take a Campagnolo specific cassette. If your frame was much older, I'd also suggest that you check the spacing between the dropouts to ensure there was sufficient room. One area I have run into that's worth checking, is that if you intend to use an 11t sprocket at the rear with a compact chainset (or triple) that there is sufficient practical space between the chain and the chainstay.

You should be mindful of the bottom bracket setup on the R2 and make sure that any new Campagnolo system is compatible with it, or that you have a relevant converter if required. The same goes for the front mech, make sure your new one is the same (band or braze on) as the existing Shimano one.

Again, not a problem for the R2, but if your frame was setup for longer reach brake calipers, I'd also suggest that you measure the existing ones before you order, to ensure that the new ones have sufficient depth.

If in doubt or if you want extra reassurance, I'd check in with your local Scott dealer to get their confirmation, they may also be able to offer advice on subtle changes they make when setting up for Campagnolo which will make your transition smoother.

share|improve this answer

You'd have to change the rear wheel or have it rebuilt on a campy hub (the shimano hub is not compatible with campy cogs), and of course all the components. That said, nothing should need to be changed on the frame itself.

share|improve this answer

No. There are no frame changes required. The only time I could imagine this would be required is if you are looking at the electronic groupos, and frames that have specific battery mounts for one particular groupo. However, even then I'm sure there'd be a workaround.

share|improve this answer

I don't think you will need to change the frame, I looked at one of the bianchi series a while back and I saw the same frame (the Oltre - I can but dream) offered at different prices depending on the groupset. But the groupsets available were from both shimano and campag. There's variations with Dura Ace, Ultegra, Athena, Super Record etc. I can't imagine the actual frame would be different between these groupsets, otherwise surely it would have a different name?

Here's the link to that page: http://www.bianchi.com/Uk/Bikes/Bikes_List.aspx?RangeIDMaster=74825&CategoryIDMaster=74829

You may want to visit the Scott site, you may find something similar

However I can imagine you're going to have to change just about everything else, though, including wheels (well, as far as the freehub at least).

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.