Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

What's the best way to tune the rear derailleur of my bike to stop slipping gears? It seems that every time I re-adjust it, the middle/upper gears are perfectly aligned, but the lower gears never stay put. When I'm climbing up hills, the chain keeps slipping up/down a gear, and never stays put.

share|improve this question

4 Answers 4

Ok, a number of the other responses have captured some of the possibilities here. The possible causes and fixes I can think of are:

  • Worn Cassette, which is also usually associated with a worn chain. If this is the issue there are two key indicators that you will see. The first is that the gap between the teeth on the sprockets will look less like a "U" and more like a "V". The second is that the chain will measure more than 12.7mm between each rivet. Sheldon Brown has more information on this here. If this is the case, then the cure is to replace the cassette and the chain, and quite possibly the chain rings as well.

  • Bent Derailleur Hanger. When viewed from behind, the derailleur cage (with the two jockey wheels the chain runs over) should be vertical. If it isn't, you'll need to either bend the derailleur hanger (carefully) to the correct alignment, or replace the derailleur hanger (if it is replaceable). I wouldn't try bending the hanger myself - I'd take it to a bike shop.

  • Friction in the Gear Shift Cables. A bit difficult to tell if this is the issue, but realtively easy to fix. A temporary fix involves putting chain lube on the points where the cable enters and exits the cable outers and changing the gears around a bit. A better solution is to remove the cable from the outers, wash it with degreaser, clean and dry it, then re-fit it to the bike. If the end of the cable is worn, it can be difficult to re-fit it. New cables are pretty cheap, so you may consider replacing the inners and outers.

  • Weak Derailleur Spring. Unless you have a fairly expensive deraileur, you can't replace the derailleur spring. You can stave off the inevitable for a bit by cleaning and lubricating the derailleur, but ultimately this means it is time to get a new derailleur.

share|improve this answer

The chain may not appear worn - but check to see if it's stretched. Check this comment with a quick way to measure your chain to see if it's stretched.

share|improve this answer

To add on to Mike's answer, slipping is probably due to your chain being old. As a result of your chain being old, it has probably worn down the teeth on the rear cassete (you should be able to examine it and see grooves and uneven wear on the gears you use the most). Replace both the chain and cassete, then get yourself a chain wear indicator and check it periodically to prevent your chain from destroying your cassete again.

share|improve this answer
4  
Make sure you replace both the chain and the cog. If you do one or the other, the chain will still jump because the wear no longer matches. –  LoganGoesPlaces Aug 25 '10 at 20:31

If your derailleur is adjusted properly, and you are slipping gears, it's usually a worn chain and rear cog. Take the bike into your local bike shop, and they can help you get replacements.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.