Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

So helpful folks here helped me get the cog and lockring off, and now I'm stuck with this. I looked on Park's website again for "removal of freewheel" help, but mine didn't fit with any of the methods. No hex wrenches, screws, bolts or anything. The ratcheting mechanism just seems sort of...on it.

There's two notches (picture below), screams "two-pronged tool" but I'm starting to think this wheel simply cant be converted to a fixed wheel. New rear wheel perhaps?

enter image description here

share|improve this question
1  
Try using a putty knife or something on those two notches. –  ekaj Jan 12 '13 at 3:26
add comment

2 Answers

up vote 5 down vote accepted

If the notches are about 25 mm apart, this may be your baby:

enter image description here

On the Park Tool website there are two very informative documents on freewheel removal, and destructive freewheel removal, which should answer all your questions.

share|improve this answer
    
Man, how did I miss this...? –  Knarf Jan 12 '13 at 5:51
add comment

There's a special tool that matches those notches so you can dismantle the whole thing.

However, yeah, you'd be better off with a new rear hub. You can reuse the rim, if you get a hub with the same number of holes, but you'll need new spokes.

You're going to need to know the spacing of the rear dropouts on your frame and find a track hub that matches that.

For mountain bikes this is usually 135mm, 130mm for road bikes, and 120mm for track bikes.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.