Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

Would you recommend for a good grip from Shimano Nexus shifter? I hardly find a good option. Ergon grips seem to be the best choice.

share|improve this question
add comment

1 Answer 1

Choosing a grip is a matter of personal preference. If you're worried about the fact that the Nexus shifters require a smaller grip on one side than the other (due to the shifter taking up room), you can get grips that are made to mate with an internal hub shifter like the Nexus.

Alternately, since these can be difficult to locate, you can cut down the grip on one side with a hacksaw blade. That's what I did on one of my folding bikes, and it worked fine.

Just be sure to cut the grip in a straight line. You can mark the location of the cut with masking tape or painters tape before sawing to get an even edge. The edge will be slightly rougher, but since it'll be sitting up against the shifter it won't be very visible. If you want to cut down a non-locking grip, you can probably do something similar.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.