Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I have a 105 triple chainset (hollowtechII) and the left hand side has developed a crack. Now I can't find any replacement 105 LH cranks but there are some Deore ones on the ebays that aren't too expensive.

So will they fit? I know since it's Shimano nothing is compatible with anything else, you're supposed to just go out and buy a whole new bicycle, but I'm hoping…

share|improve this question
2  
I know since it's Shimano nothing is compatible with anything else. ??? Not in my expereince. Shimano's different ranges tend to be very compatible with each other. But as @Alex says the Deore is a Mountain range and you need one of the Road ranges. Check out Tiagra or Sora (Ultegra will also be compatible but if bought new, will be more expensive than 105) –  PeteH Feb 14 '13 at 21:09
add comment

4 Answers

up vote 2 down vote accepted

Mountain bikes have wider chain stays than road bikes so the cranks need to be further apart to prevent them (or the cyclist's heel) from banging into the frame. The distance between the pedal attachment points on the crank arms is referred to as the Q factor. Typical Q factor for road cranks is ~150mm; for mountain cranks it is ~175mm. This means a mountain crank is likely to be 10-15mm further from the frame than a road crank.

Small differences in the crank symmetry aren't that noticeable, but I suspect that 15mm might be. Also worth noting that many people believe that narrower cranks are more comfortable and efficient, which is why manufacturers produce their road cranks with a lower Q factor.

If you want to replace your cranks on the cheep, I would try to find a second hard pair compatible with your existing chain rings and bottom bracket. Do swap the chain rings, even if the replacement crank has rings, because differences in the wear between rings and chain can accelerate wear and cause chain slippage.

share|improve this answer
add comment

All Shimano Hollowtech II road crank arms are compatible, however, the Deore is a mountain range. I don't think these are compatible, but I can't find anything.

You might want to look for a HT2 road crank arm. The Shimano road ranges are DuraAce, Ultegra, 501, Tiagra, Sora and 2100. Not sure if these all offer HT2 cranks.

Also, you'll need a special tool (TL-FC16) to install the preload cap.

share|improve this answer
add comment

As mentioned by Alex, Hollowtech parts are compatible. If all you're replacing is the left-hand crank arm, the only thing that you need to worry about is that it is the same length as your existing crank arm. Whether it's for mountain or road bikes, crank arms come in a variety of different lengths.

The weight will likely be off if you get any type of crank other than what's already on there. Cheap cranks tend to be heavier on average than more expensive cranks. But you're probably not going to notice the difference. Except maybe when you take your feet off the pedals with the heavy one in the back position and gravity pulls it downward.

Other than that, a mountain crank will probably look funny and that's about it.

share|improve this answer
add comment

Be careful because even if you find one with matching interface, it might still be heavier than right arm. It would not be end of the world but it might feel a little funny.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.