Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I'm quite new to bikes. I have a Schrader valve bike with deflated wheels. When I try to pump it up. I take off the protective cap, then there is a valve secured down by a nut (there is another nut securing it to the actual wheel) I then put the pump onto the bit of valve poking up and lock it in. I can then pump it completely with about 5 pushes of the pump. Once it is complete I unlock the bike pump off of the valve, at that moment all the air rushes out immediately (10 seconds) even if I put the protective cap on. What does this mean??

share|improve this question
    
Very strange. The protective cap has nothing to do with air retention. It is to protect the valve from mud. Do both tires behave in this way? Are you sure it is a Schrader? –  Vorac May 23 '13 at 9:10
1  
Do you mean presta? Schraders have either 1 or 0 nuts. –  alex May 23 '13 at 9:48
    
A Schrader has no nut securing the valve. It does have a "valve core" which can be unscrewed for replacement or to let the air out of the tire, but you should leave that alone. If instead you mean Presta, there are several good descriptions here on how to inflate one. (And I doubt that any normal bike tire can be properly inflated with 5 pushes of a floor pump.) –  Daniel R Hicks May 23 '13 at 10:54
    
This link shows the Schrader and Presta valves. –  Daniel R Hicks May 23 '13 at 10:58
3  
Five pumps sounds suspiciously like "I screwed a Presta valve the wrong way, so none of my air is actually going in the tyre. After five pumps I can't get any more in, so I take the pump off, and the air comes out". But you would have thought he would notice the tyre was still flat in that case. Even a small child's bike tyre takes more than five pumps to actually inflate from flat to normal pressure though. –  armb May 23 '13 at 15:02
show 1 more comment

1 Answer 1

From these three, which one you have?

Case ①:

Schrader valve

Schrader valve

Check if the inner part (valve) is properly installed (tight enough). If is and still loose air — you need to change the valve or the inner tube, the problem is with one of them.

Case ②:

Presta valve

Presta valve

You need to unlock the valve before pumping, or you will pump air only into you pumps' hose. After pumping don't forget to lock the valve back.

Case ③:

Woods (Dunlop) valve

Woods (Dunlop) valve

Very old system. Check inner parts (steel needle and rubber tube) for damages, rubber tube can degrade flexibility with years → air loss.

share|improve this answer
    
Thanks for the replies. Sorry about the description it is case 3 the Dunlop valve. Thanks –  jamee May 24 '13 at 5:16
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.