Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I have experienced a strange failure of my brake.

I was descending a steep smooth road, using only my front brake (my rear brake was broken; it was an unplanned bail from a route). I tried keeping the speed low, so i could jump off the bike at any moment.

After going this way for maybe 2 minutes, I stopped briefly to let some car pass (so released the brake for a few seconds). As I continued to descend, I pressed the brake, and surprisingly, its handle went all the way to the handlebar without doing any braking! So I immediately jumped off.

I didn't believe at first the bad luck I had, but then I pressed again and again on the brake (not while riding now), and gradually it returned to normal; after 1 minute it would give full braking force again.

So I wonder, is this an expected way a brake would fail while overheating? I heard that it would start to stink really bad before it became dangerous to ride, so I didn't worry about overheating.

The model of my brake is Hayes Nine.

share|improve this question
This is why I only run cable actuated brakes. Random, sudden failure of my brakes is not something I ever want to deal with. –  Benzo Jul 27 '13 at 13:58
I've never had any random sudden failures and have been using hydraulics for seven years. My Shimano Deore hydraulics worked flawlessly for six years without requiring anything more than new pads. –  James Morris Jul 28 '13 at 9:58
@Benzo: Mechanical brakes are not an option for aggressive trail or downhill riding. All technologies have pros and cons. –  cherouvim Jul 30 '13 at 9:04

1 Answer 1

up vote 10 down vote accepted

The least you need to do is bleed the brakes to remove trapped air. It's best though if you completelly change the fluids and bleed. You can do that in an LBS, or yourself if you have a bleeding kit and know how to do it.

The reason for the behavior you described is that air is trapped in the system and makes things mushy and unpredictable. The fact that after a couple of lever presses it came back to "normal" is because hydraulic brakes are auto adjusting both on the pads end (when pads are worn) and on the lever end (when air is in the system).

Air bubbles exist in the system either because a proper bleed was not done in the first place or because the fluids absorbed moisture which vapourated and turned into air as soon as you overheated the fluids. Also note that as soon as the fluids absorb moisture (water) then the boiling point falls even more so having this issue is even easier.

share|improve this answer
+1 for bleeding, though I've had a case where steam came off the front caliper due to piston, bore, banjo bolt, and bleeder seals needing replacement –  moshbear Jul 28 '13 at 12:49
brake fade isn't just for cars. –  Chris H Jul 29 '13 at 10:26
@ChrisH: +1 for the wikipedia article which explains the fluid fade. –  erik Jul 17 '14 at 1:38

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.