Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I saw this. However, looking at a old 7 speed freehub body, it looks like it takes a special spline wrench (TL-FH10). It looks very similar to the fixing bolt here. Or do I need some other wrench to remove it using the notch? I also did see this.

Do I need this special tool to remove this freehub body or am I totally off? Is there some other way to remove it without destroying it?

UPDATE: The freehub body does not have notches on it. I will post a picture of it.

share|improve this question
add comment

1 Answer 1

up vote 0 down vote accepted

Just a 10mm allen wrench was needed. Looking at the head for the bolt, it looks special, but its not, so I was deceived. Probably not a traditional bolt head, as the axle must fit through it.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.