Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

I am curious if anyone has put larger tires (mountainish) on their road bike. I am thinking about doing this to do some riding on gravel roads/touring/commuting from rural areas. I have an older steel Norco. How rough can I ride this with bigger tires without damaging the bike? (Purely just for curiosity. I am not planning on doing any drops etc but if I drop off a curb now and then does that matter?)

share|improve this question
Large wheels on a road bicycle is done for cyclocross events. Think racing, on road, off road, on foot, and mud. – Greyhound May 4 '11 at 22:50
up vote 7 down vote accepted

Road frames come in a wide variety of styles, so it's impossible to give an exact answer without knowing more about your bike. Also keep in mind that wider tires also have a larger diameter, so your bike has to have enough clearance for both.

A typical modern road bike with caliper brakes is going to have very tight tolerances: many will max out at a 28mm tire, some at only 25mm. When mine was built, I had the frame customized and used long reach brakes just to allow 28mm tires plus fenders -- even then it's a tight fit. Another problem with calipers and wide tires is that you may not have enough brake cable slack to remove the wheel easily (I have to deflate mine slightly to get the tire past the brake shoes).

Touring and cyclocross frames tend to be built with much more generous proportions and have room for bigger tires. Using cantilever brakes also helps give much more tire clearance vs. calipers. My last touring frame used 32mm tires and could have easily gone up to at least 35mm, if not bigger.

If you're putting on much larger tires, you should also consider larger rims (see Sheldon Brown's tire/rim sizing chart). Using a big tire on too small a rim is a recipe for trouble. Plus a wider rim adds more strength. So you may need a wheel rebuild to make this happen.

share|improve this answer
If the pinch point is the front derailleur's band (if band-on type) you could use a carbon band to give an extra mm or two clearance at that point – inbike Apr 27 '15 at 11:33

Well, it depends a lot on the specific model of bike, and likely even on the exact frame size. You can probably eyeball it to get a good idea. Remember that larger tires are both wider and stick out more from the wheel. On a road bike, odds are high that you can put a slightly larger (say, go from 25mm to 30mm) tire but not a hugely larger tire. If you want to make a big jump you probably also want to get wheels with a wider rim. Note that for off-road tires, the knobs aren't usually counted in the mm size but definitely do affect whether or not the tires fit on your bike.

Look for:

  1. Front and rear: Brake clearance — can a larger tire fit in the brakes? If this is the only issue, you can get different brakes
  2. Rear: Stay width — will a wider tire rub on any of the stays (rear)?
  3. Rear: Stay bridge clearance* — will a larger tire hit the bridge between seat stays or chain stays?
  4. Rear: Seat tube clearance — many bikes have a geometry where too large of a wheel/tire will hit the seat tube above the cranks
  5. Front: Fork clearance — how much room is there under the fork crown? (height and width)
  6. Front: Down tube clearance — how much extra room before the front tire hits the downtube?
share|improve this answer

If your bike has 700C wheels, you could convert to 650B. The wheel radius is only 25mm less, so most things work the same, but you have that much more room for tires and fenders.

You'll probably need to replace your brakes with long-reach brakes.

share|improve this answer
+1 for remembering to mention the switch to long reach brakes with this suggestion. – Gary.Ray Oct 26 '10 at 3:00

For our small expedition with our bicycles in Patagonia we invested into slightly larger tires and more durable ones (we choose the Schwalbe Marathon XR in 700C, the widest our bike frame could accomodate).

It did quite a change, you hear more the tire noises, it helps better in muddy terrain and feels more confortable in gravel roads or in the fields. However, it's not really good in sandy parts or when the gravels are too big or too loose.

Overall it was a good and needed change, it would have been much less confortable to ride down in Patagonia with out those wider tires.

If you decide to change yours, follow freiheit advice or go pay a visit to a local bicycle shop. It's not always possible to put different tires because of the rim, brakes or frame.

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.