Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

Are there adjustments that can be made instead of replacing it?

share|improve this question
    

4 Answers 4

up vote 9 down vote accepted

It depends on what you mean by 'loose'... Chains stretch naturally over many hundreds of miles, and the stretching of the links is actually a good indicator of wear.

If, instead, it seems like there is a lot of slack or 'extra' chain, this is an indicator of one of two issues:

  1. The chain is simply too long. All new chains (not already on bicycles) come longer than they need to be. If you recently replaced your chain, and didn't remove the extra links, this would cause the chain to be loose.
  2. The dérailleur is not creating chain tension. If you find that the chain seems to sag at both the top and the bottom, this may mean that your dérailleur has lost some of it's 'springiness' and is not effectively creating chain tension. It's hard to determine without further details, but if this is the case, the dérailleur may need to be replaced.
share|improve this answer
    
To amplify the frist part a bit, if it was once fine and is now slack/loose then replace it - there's no reason why it has to be a particularly expensive for a upright (slightly different for the 2.something chains needed for my recumbents) and its an easy job to do - even more so with contemporary chains with clever links. When doing the replacement compare the old and the new and you'll see how wear has caused it to "stretch". In theory you're supposed to replace other stuff too... but that does get expensive. –  Murph Aug 25 '10 at 20:39

I believe you can just remove a link if it's that loose. But beware that more stress could cause it to break.

share|improve this answer
    
I've done this when I was waiting for a new chain. This is a common temporary solution. –  Neil Fein Aug 25 '10 at 20:57

If the bike has hub gears, then you can undo the wheel nets and firmly push the wheel back into the axle slots while doing up the nets. There is a neck to this, as you don’t want chain too tight and you need the wheel to be aligned when turning.

share|improve this answer

you can loosen the back tire then pull it back so the chain is tight. After you do this you can tighten it into place. TADAH! Now your bike is fixed

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.