Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I've got a 20 year old Cannondale mountainbike (model # scratched off long ago). It's been used as a daily commuter for a few years and for a couple long trips. I've been told that the original chainring and cassette need to be replaced but I don't know anything about sizing and compatibility. How do I go about choosing replacement parts?

share|improve this question
    
First, make sure it has a cassette and not a freewheel. Next, you will need to decide if you want to stick with the # of speeds you have or not. –  sillyyak Apr 1 '11 at 12:53
add comment

1 Answer 1

up vote 4 down vote accepted

Assuming Shimano components.... You shouldn't have any difficulty with compatibility. However, as noted above, you need to find out if you have a cassette/freehub or a freewheel. At 20 years old I imagine you're looking at a freehub...
And likely 7 speeds. If you want to go to a more-modern 8-speed cassette, the spacing should be the same but you'd need new shifters. The crank may or may not have replaceable chainrings, and if it does they may not be easy to find. Nashbar used to sell a wide variety of chainring sizes and bolt-patterns, but current catalogues do not show these. Likely available from outlets like Loose Screws. Note that some cranks may appear to have replaceable chainrings but they are in fact permanently attached and you have to replace the whole crank.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.