Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

As a child I had solid rubber inner tubes in my bike. They were a pain to get on but after I never had a flat again!

Now I've recently started biking again and have had two flats in two days, each resulting in a three-mile walk back home. I've been searching for solid rubber tubes for a few hours now, but have only found them at wal*mart, and they don't have the correct size? (700x38c)

Why have they disappeared? I thought they were a fantastic product . . .

share|improve this question
    
You could try getting puncture resistant tyres, e.g. bicycles.stackexchange.com/questions/27 –  Wilka May 25 '11 at 16:22
    
I remember maybe 30 years ago seeing solid tubes advertised, but haven't seen them recently. They are no longer really necessary (if they ever were) given that modern aramid-belted tires are virtually puncture-proof. Basically, the market dried up. –  Daniel R Hicks May 2 '12 at 1:17
    
I used some tyres from greentyre.co.uk/bike.html for a few years because I was getting a lot of flats on one particular commute route, for reasons I never did work out. (Still available in the UK, but I bought them from a local shop which no longer stocks them.) They sucked (and unless they've changed design, "easier to install than a normal bike tyre" is an outright lie - they certainly weren't going to roll off though), but not as badly as the flats did. Then I changed commute. (And then I bought some Marathon Plus tyres, but that was a different bike with wider tyres.) –  armb May 9 '13 at 9:25

5 Answers 5

up vote 21 down vote accepted

You should not be getting multiple flat tires in such a short timespan. I commute on poorly-maintained roads in Atlanta, and have not had a flat tire in 4,000 miles.

In order of estimated likelihood, either:

  1. your tires are not properly inflated
  2. your tires are worn or punctured and need to be replaced
  3. you have a sharp object embedded on the inside of your tire
  4. you are exceedingly unlucky

If you've just started cycling again, I think it's exceedingly probable that you've simply neglected to inflate your tires to their recommended pressure. Standard road tires should be inflated to pressures of 100PSI and beyond. Mountain bike tires (which are awful for road use, but I digress...) require much less. It's easy to grossly underestimate how much to inflate a bike tire, and a standard hand pump will likely only get you to 30-60 PSI before you give up.

Take your bicycle to your nearest bike shop and have them examine the situation. Flat tires should not be a common occurrence.

share|improve this answer
4  
This doesn't answer the question I stated, but it is getting marked as correct because you are spot on: it was problem #3. –  JIStone May 23 '11 at 23:30
    
It should also be noted that there are some tires that are fantastic that at resisting punctures. If that's a particular problem ask your LBS about your options. There are also some other related products that can be used if you can't find tires that suite and have the puncture resistance. –  Colin Newell May 24 '11 at 12:04
    
Not everyone needs 100psi plus. bikequarterly.com/images/TireDrop.pdf (PDF) –  James Bradbury May 1 '13 at 11:58

I came across a solid tire. SERENITY

share|improve this answer

To answer the actual question, they are no longer sold in the US. In most locations, they aren't legal to sell. A bicycle tire uses the pressure from the inflation of the tube, (or in the case of tubeless tires, the tire itself is inflated), against the casing of the tire to lock the bead of the tire into the rim.

Without that pressure lock, the tires roll off the rim.

Since a solid tube or solid manufactured tire can't by definition inflate against the bead, they were both abnormally hard to install, and prone to rolling off the wheel in use. So they were considered unsafe, and are no longer sold anywhere that I am aware of.

Certainly, no reputable shop will sell them.

share|improve this answer
1  
I'm not sure how a solid tire rolling off the rim is more dangerous than having a pneumatic tire blowout? Both seem to be equally bad. Only difference might be in how often it occurs? –  Brian Knoblauch Jun 20 '11 at 13:39
6  
When a solid tire rolls off the rim, it is extremely likely to cause mischief. For instance, think about 2 inches of solid rubber jamming itself between your fork and your front rim at 15-20 MPH. But you're right, the main reason is that is certain that you will have a problem with a solid tube or tire. On a pneumatic tire, you usually have the ability of riding out the flat. I've had several major blowouts, but never crashed because of it. –  zenbike Jun 20 '11 at 14:02
    
If you inflate a rubber doughnut, the entire object will get bigger. Both diameters increase: inner and outer. So, as you add pressure to a tire, it basically wants to pull away from the rim. A solid tire can be stretched onto the rim, and basically press tightly into it like a rubber band. Between the two, my money would be on the solid tire staying in place. –  Kaz Sep 23 '12 at 7:21
    
@Kaz, I understand the thought, but the rim is designed to hook on to a pneumatic tire, and the increase in pressure actually increases the security of that hook. (Up to a point. Going to far with anything is bad.) But a solid tire which is made tight enough to be secure on the rim, is a tire which is too tight to be installed on the rim. Since the tire has to be installed, there has to be some give in the tire, and that give is what allows it to come off the rim, especially during cornering, even at speeds which would be considered slow on a pneumatic tire. –  zenbike Sep 23 '12 at 8:17
1  
Yes. What is asked about is what is available: what is the state of the art of airless bicycle tubes, from the perspective of today's consumer. (But even if that is not so good, let's not damn the whole concept.) Regarding how you would change that tire? The special wheel could have a way of doing that (E.g. a rim that disassembles by splitting radialy). Or simply the entire wheel could be treated as recyclable. You get a new wheel (or refurbished one) and the old one goes to some factory to be refurbished. –  Kaz Sep 23 '12 at 16:19

Carry a flat-fixing kit. You don't need much; patches, tire tools, something to inflate the tire again. Small, light frame-mounted pumps are readily available, and if you don't want to pump, CO2 inflators. You can even get hand-clean-up goo in handy little packs.

With a bit of practice you can be rolling in about the same time needed to change tires on your car.

As well, you can take preventive measures. Avoid super-light tubes. Keep your tires properly inflated. Keep an eye out for visible hazards like potholes and broken car-window glass.

share|improve this answer
2  
Unfortunately, this answer doesn't actually mention solid tires. –  amcnabb Sep 19 '12 at 4:54

Basically, they're harsh and hard on your wheels. A quick look at Sheldon Brown's site will tell you more:

Airless tyres have been obsolete for over a century, but crackpot "inventors" keep trying to bring them back. They are heavy, slow and give a harsh ride. They are also likely to cause wheel damage, due to their poor cushioning ability. A pneumatic tyre uses all of the air in the whole tube as a shock absorber, while foam-type "airless" tyres/tubes only use the air in the immediate area of impact.

Also, many shops will discourage airless tires. It's certainly possible they may get better given time, though, so it's worth keeping an eye on the situation.

To address the other part of your question, they're still available, but a specialty item. I found quite a few of them on Google Products, although finding them in 700x38 might be a challenge.

share|improve this answer

protected by freiheit Dec 28 '12 at 3:15

Thank you for your interest in this question. Because it has attracted low-quality answers, posting an answer now requires 10 reputation on this site.

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.