Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I have single speed bicycle with a straight dropout.

The problem I'm having is that over the course of a week, the chain loses tension until eventually, if I do not re-position the back wheel again, leads to the chain coming loose.

This is a minor annoyance while the bike is configured on its freewheel, however, it could be positively dangerous if I used the fixed gear.

What am I doing incorrectly?

Are there any spacers I can fit in to the drop-out to alleviate this problem?

Or perhaps it's the fact I'm using a multi-tool to tighten the bolts. Maybe I need a tool that gives me more torque?

Your advice is much appreciated.

share|improve this question
    
if you decide to go with a chain tug, let me know; I think I have one in my parts bin that's been unused for years. It's yours for the cost of postage. –  Neil Fein Jun 20 '11 at 3:17
add comment

2 Answers

up vote 2 down vote accepted

You need to get a tuggnut (also known as a chain tug). Surly has an excellent one that I use. I was getting the exact problem that you were until I got the tuggnut and since then haven't had a problem. They also sell cheaper ones at BMX shops or you can search on eBay for "Chain Tug" and find many cheaper options.

The other bonus is that it makes adjusting the tension really easy. You can dial in just the right amount of tension then take your time getting the wheel straight and the bolts tight.

I would also recommend getting a better spanner so you're not going to ruin the wheel bolts, but even with a ratchet I was still getting slipping. The tuggnut will solve this completely.

share|improve this answer
add comment

The problem is almost certainly that you're not torquing the bolts on tight enough. They need to clamp down tight. A multitool is going to get you nowhere near the amount of torque you need. I use Pedro's Trixie for my track bike.

share|improve this answer
    
Danger! Check the photos on hhh's hub gear problems: bicycles.stackexchange.com/questions/3449/… Overtightening those nuts will strip them (or the axle). Whether you can apply enough torque depends on the multitool, but it probably can't. I'd still be cautious. –  Мסž Jun 20 '11 at 0:22
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.