Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

The ends of my rim tape are about 1mm apart, but the spoke holes are covered. Is this ok, or should I pull it off and start with a fresh roll? Here's a picture.

share|improve this question
    
FYI. Picture link is dead. –  Benzo Aug 27 '13 at 17:02

3 Answers 3

up vote 8 down vote accepted

This is usually ok. as long as it has strong enough adhesive to stay in place. It's better to overlap it, of course, but as long as the spoke holes are covered it should be ok.

A bigger issue is that usually, when the tape comes up short, it means that roll was designed for a 26" wheel, and is going on a 700c rim. If that is the case, make sure the tape is not too wide, because if it is, it prevents the bead of the tire from seating, by filling some of the space in the beadlock on the rim.

If it curls up on to the side walls of the rim at all, that is not a good option. There are different widths for 26" tape, so even if it is 26", it can still be the correct width.

share|improve this answer
    
Thanks - it's 700c tape, but I was a little aggressive in cutting it. –  Thalecress Jul 15 '11 at 16:24
    
Ahh. Typically, the rolls are sized to overlap just enough. You shouldn't need to cut it. Unless it was off a shop roll, bulk style? Otherwise it should overlap by about 3 inches, which is intentional. –  zenbike Jul 15 '11 at 16:31

Should be OK. I wouldn't advise duck tape, as it will tend to make a mess, and will eventually dry up and move around anyway. Hockey tape would work fine to fill the gap, if you feel the need.

share|improve this answer

You should be fine - the primary purpose of rim tape is to protect from the spoke holes. If you are at all concerned that there's some rough in that small gap, a small peice of duct tape to bridge the gap would probably suffice (when isn't duct tape the answer?).

I wouldn't waste a roll of tape for the sake of a single millimetre!

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.