Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

So I did a couple of wet rides last month, and I guess I didn't dry the pedals as well as I should have. I have Crank Brothers Eggbeater pedals, and I noticed a bit of surface rust on them that I'd like to remove. What are my options, considering that I can't really disassemble the pedals, and they have a large number of surfaces that are hard to get to?

share|improve this question
    
Where is the rust located? I've had a Candy-SL pedal fail near the base of one of the clips so make sure that area isn't weakened from corrosion. –  darkcanuck Sep 2 '10 at 0:17
add comment

2 Answers

You're probably best with a metal brush the consistency of the items recommnded in the question below. Ultimately it's gonna happen though so all we can do is our best to dry up and clean up items. At some point they need replacing. A bit of light oil on the pedal the night before a wet ride might help keep of the rust by not letting water in. Of course it will attract dirt (hence the night before recommend so it dries).

http://bicycles.stackexchange.com/questions/478/dealing-with-rust-on-a-steel-frame

share|improve this answer
add comment

I wouldn't worry about it too much, the rust will be worn away over time as you use them. For the future though, you could dry the pedals off after wet rides and periodically apply a small amount of light lubricant to the springs, etc.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.