Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

I have a frame that I want to use. It is an old early 80's Cannondale frame. How do I tell what size threaded headset to use? What diameter should the tube be?

share|improve this question
    
Check the diameter, but it's likely to be 1 inch. –  OMG Ponies Nov 18 '11 at 5:09

2 Answers 2

up vote 2 down vote accepted

If you have the fork in hand, it's easy enough to directly measure the outer diameter of the steerer tube using a set of calipers or a ruler across the top. The common threaded headset size is 1" (25.4mm), but 1 1/8" (28.6mm) is not unheard of.

If you have only the frame and are trying to measure from the inner diameter of the head tube, then you are measuring for the outer diameter of the headset cups. For a 1" headset this should be 30.1mm, for a 1 1/8" headset this should be 33.9mm, give or take at most 0.2mm.

1980's should be too early, but Cannondale also experimented with oversize head tubes at several points - if the fork or frame is larger than that specified for the 1 1/8" size, you'll probably want to look into a different fork, and probably a reducing headset as parts are going to be almost impossible to find.

share|improve this answer
    
To be specific, it's the outside diameter. You're right, the oversize Cannondale tubes were much later - and they were all threadless, so this one can't be it. –  Mike Baranczak Nov 19 '11 at 6:38

I have only been able to find a headset that measures 1-5/16" on the small end of the bearing cup that goes into the headtube on the bike. All of the bearing cups I've found is 1-3/4" on the large end and take a large diameter bearing. The headset that I have is a 1-5/16" bearing cup o.d. but the large end of it measure 1-5/8". Where do I find a headset like that?

share|improve this answer
1  
Welcome to the site, but please be aware that this is not a discussion forum. Please use the Post answer button only for actual answers. –  Neil Fein Jul 24 '12 at 2:53

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.