Take the 2-minute tour ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

Can I insert a carbon seatpost up to 20cm deep into seat tube? The seattube is carbon as well. Total length of the seatpost is 35cm. The shape of the seatpost is aero seatpost (tear drop shape). It's a Pinarello Dogma.

share|improve this question
    
Is the teardrop shape the entire length or just the exposed section? –  mikes Jan 9 '12 at 21:53
    
Are you sure the bike fits you? –  Stephen Touset Jan 11 '12 at 6:24
add comment

2 Answers

up vote 2 down vote accepted

On most frames, yes, you can put as much of the post into the frame as you'd like. However, you are likely to remove graphics, and scratch the top coat of the carbon, so if you care about things like that, don't put it farther into the frame than is necessary.

If it is a permanent position, cut it, as suggested above. Be sure to check the manufacturers' recommendations for your post. Not every post can be cut to any length.

If you need to, try to put it at that position, gently. If anything stops, sticks, blocks it, or doesn't feel right, stop.

share|improve this answer
add comment

Sure you could, Only the top two or three inches of the seat tube are machined to match the diameter of the seatpost. But my question is why you'd want to do so. Cut the seatpost off!! You don't need more than about 4 - 5 inches inside the frame. Put a fine-tooth blade in your hacksaw, wrap some good tape just above where you are going to cut it, clamp the part you're cutting off in a vise, and saw away--gently--don't press down too hard on the saw. It'll turn out just fine.

share|improve this answer
1  
Sawing carbon by yourself can fray the fibers. If you insist on doing this, get a carbon-specific blade (it will effectively "sand" through rather than cut). –  Stephen Touset Jan 11 '12 at 6:23
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.