Sign up ×
Bicycles Stack Exchange is a question and answer site for people who build and repair bicycles, people who train cycling, or commute on bicycles. It's 100% free, no registration required.

My used bike came with a 700x28 tire in front and a 700x23 tire in back. Should I leave the wider tire in front, or should I switch the tires? What benefits or drawbacks are there one way or the other? Is there any particular reason why the previous owner might have chosen non-matching tires? Is there any reason I should go out of my way to buy a new tire to make them match?

The found a little bit of information about tire sizing, but I still don't feel like I know what to do.

share|improve this question

4 Answers 4

up vote 11 down vote accepted

Generally on a road bike it is considered better to run tires of equal size.

There are a few newer tires which are designed to run different sizes front and rear, but they are usually within 2 mm of each other. (Like the Continental Attack/Force combination)

I would consider a jump from 28c to 23c somewhat large.

That said, run the larger on the rear. The higher air volume will make for a more comfortable ride, and the narrower front tire will steer quicker, which makes for more reactive handling, and has a better aero profile, (which may or may not matter to you).

The comfort part will matter though, and I'd say that's a trump card.

share|improve this answer
I just switched the tires, and I'll see if it makes a difference tomorrow. – amcnabb May 8 '12 at 1:22
I'd be lying if I said I noticed a huge improvement, but it's definitely not any worse. Thanks for the answer. – amcnabb May 8 '12 at 16:11
In this case, the only noticeable improvement I would expect to see would be a benefit in handling on the front end, especially in quick reaction situations (i.e. emergencies), so I hope you haven't noticed anything yet. – zenbike May 8 '12 at 17:52

If you have to make a choice, put the wider tire on the back. Generally there's more weight on the back, plus having the wider tire in front will make make steering more difficult.

(Most likely the previous owner had to replace one of the tires and just used what was available.)

share|improve this answer

A wider wheel = more traction

Traction is important for torque and braking. Torque is driven through back-wheel and braking on both, and braking too much in the front relative to the back can result in the rider flipping over the handle-bar.

Therefore, put the wheel where it matters most, i.e. the back.

Edited in agreement with comment.

share|improve this answer
Most of your braking should be with your front wheel:… – amcnabb May 14 '12 at 17:11
Not sure if that is correct, but essentially, there is a ratio / tipping point at which any more front braking will result in a flip over. Having more traction in the front than the back will result in the rider being closer to that tipping point. – Yusufk May 15 '12 at 9:37
Reading this (… ), does support your point, because a riders weight is mostly on the back wheel. However, there is a tipping point, and having more traction in the front will result in a rider being closer to that tipping point. – Yusufk May 15 '12 at 9:42
There's no way to avoid having the front wheel being apt to lock up and flip you. The width of the tire will make only a miniscule difference, since a front wheel basically never skids (except on very slippery surfaces) -- it either rolls or locks up. (The only logical "fix" for this is my "power brake" invention that no one has ever seen fit to build. ;)) – Daniel R Hicks May 15 '12 at 11:27
Yusufk, as you slow down, you automatically lose traction on your front wheel as your weight shifts forward. Most braking power comes from the front wheel. Until @DanielRHicks' invention takes off, the best way to brake is to primarily use the front brake but to be careful not to make it lock up. – amcnabb May 15 '12 at 15:25

Larger front tire for the win, its a trick messengers use. Increase braking power w/ out increasing as much weight as running both tires large.

share|improve this answer
Well if it works for them all good. I'd say the grippiest tyre should be on the front because its harder to recover from a front wheel slide, and the larger should be on the rear for weight support. Bike messengers won't be as heavy on the rear as the average rider. – Criggie Nov 18 at 22:25
@Criggie For a road bike, the kind of friction (grip) we want from bike tires is static friction, which is independent of the contact area. Wider tires give more grip when we're on a loose surface, or sliding, and so are more use for MTBs. On a road bike, 99% of the time sliding the front tire is road rash time. – andy256 Nov 19 at 3:25

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.