1
vote
2answers
68 views

chain getting stuck between chainrings

I have an old Cannondale road bike with Suntour shifters. When I shift from the front middle ring to the small inner-most ring, the chain falls into the gap and binds tightly between the two rings. ...
1
vote
1answer
105 views

Front derailleur adjustment

I need some advice on properly adjusting the front derailleur (shimano -tourney) of my bike. I did watch youtube videos and stuff on the internet but was not able to adjust it properly. When I ...
1
vote
2answers
60 views

Looking for a narrow-cage 16T capacity FD

I'm putting a 46x30 chainring with a pretty narrow tread on a frame. On the advice of my LBS I got a Sun XCD double FD, but I'm starting to think it's not right for this application. When I have the ...
0
votes
1answer
72 views

how to adjust the derailer - apart from the L/H limiting screws

Pardon my newb terminology. My bike's chain will not stay on the H gear (the big ring) The front derailleur will not allow it. I have loosened the limiter screw out to it's maximum and, still, no ...
2
votes
2answers
139 views

Adjusting a triple front derailleur after removing largest chainring

I have a touring/commuting bike with full Shimano 105 -- triple in the front. I just removed the outer (largest) chainring and replaced it with a chain guard. It's easy enough to crank on the limit ...
1
vote
1answer
561 views

What are my options for replacing/upgrading my MTB front mech?

I recently damaged my front mech, a Shimano Acera, top swing, bottom pull, triple chainring. The rear cassette is 8-speed. So I need to replace this front mech. The original Shimano Acera is probably ...
2
votes
2answers
306 views

Shimano Front derailleur

I am rebuilding a Trek 2005 model 6500 and my spec. sheet for the bike says it has a Shimano Alivio front derailleur. Where do I find the model no. that should be stamped on the part? I don't see it ...
1
vote
1answer
3k views

Sora front derailleur set up

I'm trying to get my front derailleur to stop rubbing in the high gears, smallest sprockets. To do this I am attempting to follow this guide by shimano: ...
1
vote
3answers
2k views

Front Derailleur Not Working

I recently bought a new bike off of BikesDirect. http://www.bikesdirect.com/products/windsor/wellington2_IX.htm However, no matter what I do, I can't seem to get the front derailleur to do anything. ...
3
votes
1answer
559 views

How do I properly adjust a front derailleur?

I have a Shimano FD-TX50. How should I adjust it?
1
vote
1answer
443 views

ideal dérailleur height for a Deore on a Biopace?

Reading on every site about front dérailleur adjustment, the distance from the bottom of the outer dérailleur plate to the bigger crank cog should be "one penny". Mine is around 1cm! it does shift ...
6
votes
1answer
702 views

Putting a front Derailleur on a carbon frame

Do you put anything under the clamp on the carbon to protect it? In the past I've tightened brakes on MTB handle bars to much and wrecked them so I'm wondering.