7
votes
2answers
504 views

Do I need to plug internal cable routing ports?

I have just ordered a OneUp Components 42T sprocket and a Race Face 30T Narrow/Wide single ring so that I can convert my 3x10 drive train into a 1x10. This means that I'll be removing the front ...
9
votes
3answers
909 views

Should or can I (car) wax my frame?

Having spent the whole summer taking a bike apart, painting it and now in the process of building it again, I was thinking about waxing it. I want the finish to last as long as possible, after all, ...
2
votes
1answer
1k views

Is it possible to run standard mechanical shifting on a Scott Foil Premium frame?

The Scott Foil Premium is the highest end frame available from Scott Sports, and it is designed to run an electronic drive train, routed internally. The original reports were that this frame would be ...
4
votes
2answers
1k views

Why don't frame manufacturers ream/face their frames?

Before building up a new frame, it's crucially important to ream/face the headtube and crown race seat (and the bottom bracket, if using press-fit cups). You should also ideally chase the threads of ...
3
votes
2answers
457 views

Possible to repair a pushed in braze-on?

I have a Trek 7200 (Alpha aluminum frame) and it has two water bottle holder mountings, the top braze-on on the seat tube seems to have broken from over-tightening and has sunk into the frame. These ...
12
votes
7answers
4k views

Is there such a thing as frame failure?

Several general questions have been asked regarding how long a bike or bike frame will "last", and the gist of answers seems to be that a bike can last quite a while of the replaceable components are ...
4
votes
2answers
998 views

Is torque relevant for steel/aluminium? Where do I find torque specs?

When you are not dealing with carbon, is torque relevant? I've never seen it mentioned on the hundreds of answers here, or the hundreds of how-tos I've read elsewhere. Should I just tighten ...
12
votes
2answers
2k views

Dealing with rust on a steel frame

I have a small spot of rust on the bottom side of my steel frame's top tube (Columbus Niobium tubing). It's from abrasion during transport that I didn't notice until it was too late. The spot is ...