The freewheel is a ratcheting mechanism, that coupled with a set of gears, is that threaded onto the rear hub of a bike. The freewheel allows the rear wheel to engage and move when the pedals are spun forward, but coast freely when the pedals are stationary or spun backwards.

learn more… | top users | synonyms

15
votes
6answers
20k views

Why are higher-end freewheels so much louder when coasting?

I tend to ride relatively modest gear (Tiagra/Ultegra), but when I'm riding near higher-end bikes, I sometimes notice that the clicking sound that comes from their cassette/free-wheel while coasting ...
0
votes
2answers
22k views

how to reassemble mountain bike rear wheel hub and bearings

So I thought I would sort out my wheel bearings (after asking a few questions here first). Did the front without much of a problem, (reused the existing bearings at the moment, had not got round to ...
2
votes
2answers
26k views

When I pedal the rear wheel is not turning

I have a very old bike. It used to work perfectly, but just recently it happened that when I pedal the rear wheel is not turning. Just for notice I pedal in the correct direction, brakes are not ...
24
votes
2answers
6k views

Why does pedalling backwards not move my bike backwards?

On the BMX bike I have, pedaling backwards moves the chain but doesn't drive the wheels of the bike backwards like you would expect it to. Why is this?
3
votes
2answers
4k views

How to take apart this rear BMX hub?

As shown in the photo, what tool do I need to take this rear hub apart? I assume I need a tool which will fit in the 4 notches. The problem I am trying to fix is that if you pedal, the rear cog spins ...
2
votes
2answers
2k views

mountain bike freewheel hub stopped rotating

So I was trying to replace my rear bearings and got stuck, (see question below): how to reassemble mountain bike rear wheel hub and bearings After this I felt confident to go ahead. Was putting it ...
1
vote
2answers
226 views

What could be the reason for chain skipping

My chain is skipping only on the smallest sprocket, and it skips with every crank turn. The chain is not stretched. Also, chainrings are almost new. Could this freewheel be the reason, it doesn't seem ...
1
vote
1answer
3k views

How to determine size of freewheel?

My previous question was: How to take apart this rear BMX hub? How do I determine the size of my freewheel to replace it? I have seen on bicycle sites that a freewheel comes in sizes like 14t, 16t, ...
0
votes
2answers
111 views

Axle flex under load normal for freewheel hub?

When using a freewheel'd hub is it normal for the drive side of the axle to flex a little bit? I replaced the kickstand on my bike and the new one sits closer to the rear tire with about 2 mm ...
0
votes
1answer
148 views

Can an IGH have the same maximum overdrive-ratio as a crank-sproket setup?

Is there an IGH that gives one the maximum overdrive-ratio that one might get with a 39-53T crankset and a 11-34T freewheel? If not, what is the mechanical roadblock in making one ?