Gears in the drivetrain of a bike.

learn more… | top users | synonyms

-2
votes
1answer
69 views

Quad chainring (4x12)?

Does anyone yet make an affordable quad chainring? I would love to see a 4x12 with my staggered cog idea such that all 12 gears are shifted progressively using the 4 chainrings. Each chainring would ...
5
votes
2answers
1k views

what does a 22 gear bike look like?

I read that road bikes on average have around 22 gears and mountain bikes up to 30-40. But my hybrid only has gears numbered 1-3 on the left hand and gears numbered 1-8 on the right, so my bike's a 8 ...
5
votes
1answer
134 views

Back wheel started moving backwards when pedalling backwards

I have a 10 year old cheap 21 speed mountain bike that I have only ever done basic maintenance on (replacing inner tubes, tyres, brake pads, lubricating chain etc). I have just noticed that when I ...
1
vote
3answers
165 views

Is it better fitness-wise to ride at the maximum gear?

I just wanted to know if I will be doing more effort while riding at the maximum gear all the time, rather than changing gears constantly. My commute is an hour long, but I want it to be tougher on ...
31
votes
7answers
11k views

What's the efficiency of hub gears compared to derailleurs?

What's the efficiency of hub gears compared to derailleurs. I know that hub gears are not as efficient, a part from being heavier, how much will I loose in performance if I use hub gear?
1
vote
4answers
152 views

Gear shifts and drive speed on bikes

If I am driving in the 5th gear, can I know what is my velocity? Let's assume I am on a perfectly flat surface and moving monotonously.
5
votes
3answers
315 views

rear shifter lever gets stuck when shifting gears

All the shifting was working smoothly until my bike fell off to the ground (edit1: to my right side hitting the right side of the bike) with me couple days back. Now after about a week when I took my ...
3
votes
1answer
74 views

Chain is reluctant to shift into hardest gear on rear cassette

I have a Giant Escape, with Shimano Acera gears (3 speed on the front, 7 speeds on the back). When the chain is in the hardest gear on the front cassette, then it is reluctant to shift into the ...
10
votes
7answers
4k views

Does gear ratio affect Power?

Let me preface by saying that this may not be the right SE. I considered asking on the Physics SE, but I thought I might try here first. If it is wrong, I am not against it being migrated. From basic ...
3
votes
1answer
96 views

Can I use a 7 speed shifter on an 8 speed cassette

I am currently upgrading my mountain bike and have bought a set of wheels that accepts 8,9,10 speed cassettes but my previous wheels used a 7 speed freewheel. If i install the new wheels with an 8 ...
3
votes
1answer
154 views

Chain coming off with internal hub gear bike - why?

I have a Raleigh Caprice bike, about 7 years old, with sturmey archer 3 speed hub gears. There have been some problems with the hub gears in the past 9 months, which have been fixed by a mechanic. ...
-2
votes
2answers
276 views

What to upgrade to achieve a higher top speed?

I enjoy going fast and my current bicycle tops too early, what kind of upgrades would I need to make to achieve a taller final gear?
0
votes
1answer
90 views

Gear mis-adjustment. Loss of gears

How do I adjust the rear gears of a bike that will not change to higher gears? It is stuck in lower two or three gears.
7
votes
4answers
245 views

Best bicycle for a moderate to extremely hilly suburbs?

I've moved to an area that's notoriously hilly. I had gained a lot of weight but managed to ride it off by cycling in a well built but extremely faulty and wastefully heavy chinese bike. The gears ...
1
vote
2answers
100 views

chain jumping when puilling away in a higher gear

I replaced the rear cog as the chain I had snapped and I thought it had taken some teeth off. Now when I pull away in 1-3 gears it's ok, but if I am in gears 4-7 and I try to pull away ( say I have ...
2
votes
1answer
108 views

Changing Crankset on a bicycle

I have a fixed gear BTwin My Bike White. I need to upgrade but the resale value is too low for it. So I was thinking of adding gears to it which might click the real deal for me. Can I convert it ...
0
votes
4answers
167 views

Derailleur/Gears Locks Up/ Freezes Up/Stalls

Hey guys I have a specialized mtb with the old oval chainrings and lately it's been locking up. When I start pedalling "hard" or faster the crank stops turning and then jumps forward a bit and ...
0
votes
1answer
89 views

Combine Nexus 3 Hub with Torpedo 3 gear shifter?

I have upgraded my bike with a Nexus 3 hub, but the corresponding gear shifter takes away too much handle space on my crooked handle bar (I have to grab the gear shifter during my rides). Hence, I'd ...
0
votes
1answer
91 views

Shifter clicks in but chain stays on the largest cog, when riding

I am able to change (click through) the shifter but the chain stays on the largest cog and does not move (This happens only when riding) but the gears shift as usual when the bike is stationary and I ...
2
votes
1answer
52 views

Double XT with XX1?

Is it possible to run Shimano front chain rings(xt 36/26)with xx1 for the rest of the drive chain? Currently running xx1 with 30 upfront. Loving it although am concerned I will need smaller gearing ...
2
votes
1answer
52 views

Separating the gear hanger from the derailleur

I am trying to exchange my rear derailleur. Now I have the problem of detaching it from the hanger, as you can see in the attached image, I was able to detach the gear hanger from the frame, but I ...
5
votes
2answers
119 views

Problems with front derailleur shifting on an inexpensive bike

I bought a cheapish bike (Nakamura) couple of years ago, and it generally serves me well. Main problem that I have is that shifting gears, especially front gears often gets out of tune. After only a ...
7
votes
1answer
1k views

Effect of Rear Derailleur Cage Length

What effect does the length of the cage on a rear derailleur have on bike setup/shifting?
1
vote
3answers
474 views

Can't shift to gear one or two

I had an issue where every time I put my bike in gear 3, it would just keep "skipping". By this I mean that it wouldn't stay in gear 3; the chain would go onto it, then fall onto gear 4, then go back ...
4
votes
2answers
140 views

Poor shifting in dense fog?

I cleaned up my bike yesterday after a particularly wet and muddy week, wiped the oil off the chain, applied a fresh batch, took it for a spin and found no issues whatever with the shifting (I go ...
2
votes
2answers
143 views

triple chainring with with single speed freewheel

I have a Hero Sprint Axis (with 18T freewheel).I ride mostly on flat roads, but want more top speed and a lower gear for starting from standstill. Is it possible to just install a triple chainring ...
1
vote
1answer
144 views

Front and Rear speed shifters aligment guide

How to align the front and rear speed shifters ? My chain dropped from the front chain ring, and I put it back on the first gear I found, then the rear one fall off, and I put the chain back on the ...
1
vote
3answers
878 views

MTB with gears or non gears, suspension or non-suspension for stunts?

I am planning to buy an MTB for learning stunts...(BTW my family wont allow me to buy a BMX because of its height). So my question is shall I go for MTB with front suspension or not and with gears or ...
4
votes
3answers
91 views

cross chaining 18 speed (2 * 9) bike

I have a 18 speed bike. There are two chain rings in the front and 9 cogs at the back. I am new to cycling and I wish to know which gear combinations should I avoid to prolong the life of the chain ...
3
votes
1answer
38 views

Adjusting Gear Actuation

I recently brought a second hand bike with Shimano Deore gears on it and when I switch up a gear on the chain-ring it requires a significant amount of actuation pressure on the 'flappy' paddle ...
2
votes
1answer
3k views

Bicycle slipping gears on middle sprocket gears 4-7

I see lots of questions on gears slipping but not sure it's the same as what I have. Out of 21 gears I only have problems with 4 (middle sprocket (2) on left shifter gears (4-7) on right shifter). ...
6
votes
3answers
938 views

Different Gear Type when there's no Front Derailleur?

I have a 7 speed Jamis Boss Cruiser, 7 gears in back and one up front. I've been using it fine for several months now. Lately, the chain is coming off of the single front gear, usually after stopping ...
2
votes
2answers
362 views

Is a Shimano Dura-Ace 7800 rear derailleur compatible with a Dura-Ace 7900 11-27 cassette?

Is the Shimano Dura-Ace 7900 10 speed cassette with a ratio of 11-27 cassette compatible with a dura-ace 7800 rear derailleur? Some people say its fine but more important to me is what Shimano says ...
1
vote
3answers
19k views

How to fix problem with mountain bike chain falling off gears?

The chain on my girlfriend's bike came off the front gear today, it looks like the back gear changing mechanism isn't handling back-pedaling properly, whenever she pedals backwards the chain slacks ...
5
votes
5answers
2k views

Are single-speed bikes better equipped to handle cog/chain wear?

I need to decide between a single-speed and multiple-speed bike. I usually ride multiple-speed mountain/city bikes in the highest gear anyway (around town). They're not intended for that, and doing ...
7
votes
2answers
130 views

When is it time to replace the gear-cable housing?

Please keep in mind that this question is specific to mountain bikes which roll through lots of dirt and mud. I heard stories of bikes that had their cable housing last for years, but I doubt that ...
5
votes
2answers
121 views

Gears on a singlespeed frame

I'm building a new bike and have ridden a frame which feels (and looks) amazing. I'm dead set on buying it but it's a single speed frame. Ideally I would like gears at the rear. It has a dropout which ...
4
votes
1answer
45 views

Using 9 speed Deore front shifter with 10 speed Ultegra front Deraileur

I am trying to build a bike out of all the spare parts I have in my garage. I found a 3x9 Deore front shifter, 3x10 Ultegra front d and crankset. Would they work together? By the way, I am building a ...
5
votes
2answers
904 views

Pros and cons of gears in bottom bracket vs. rear hub? [duplicate]

Since 6 years, I am the happy user of a bicycle with a Rohloff internal hub gear. German quality squeezing 14 gears and a 526% gear range into the rear hub. Less known is the newer and equally ...
6
votes
1answer
175 views

What is the name of this type of bolt for the front crank on my bike?

I recently had to take the front gear off of my bike and had some difficulty undoing the bolts. Because of their poor condition, I have decided to replace them. However, I have no idea what they are ...
1
vote
0answers
31 views

3- 5 gear special gearset?

So, a while back when I was rebuilding my vintage Shogun 6-speed, I realized that I only use 2- 3 gears on my commutes to and from school, crew, and other daily rides. The next day, I went to my local ...
2
votes
1answer
49 views

Gears for Hero Cyclone

I have a Hero Cyclone bicycle that is a single speed. Can I add gears to it? If so, can anyone suggest me a good gear?
1
vote
2answers
110 views

Chain rubbing on new derailleur and crankset

My bicycle is a Rockrider 520. I have replaced my front derailleur with Shimano Acera FD-M390 and my crankset with Shimano Acera FC-M391. But chain is rubbing inside of FD even when FD cable is not ...
3
votes
3answers
185 views

Why is my bike slipping gears?

I have a 1997 Gary Fisher Tassajara that got a complete overhaul and tune-up at a bike shop a year ago. (to the tune of $180, but some of that was new tires- I'm the original owner) I ride between 4 ...
2
votes
3answers
125 views

Jockey pulley (upper jockey wheel) suddenly not engaging with the chain when in the three largest (easiest) cogs on the big ring only

The gears work fine across the whole cassette on the inner ring but all of a sudden the chain has stopped engaging with the upper jockey wheel when in the big ring and three largest (easiest) ...
3
votes
2answers
226 views

Road Brifters with MTB Derailleurs

I've just bought a lovely Surly touring frame and I simply stuck all of my mountain bike components on it. That means I've retained a flat handlebar. I'd really like to stick drop bars on though and ...
3
votes
1answer
189 views

microSHIFT on front gears, how does it work?

Firstly, I do apologise if I don't get all the terminology correctly but I hope I'm still clear. We bought a second-hand 18-speed bike that has a front gear system that I've not encountered before. ...
1
vote
2answers
2k views

Bike won't shift into 2 largest rear cogs (lowest gears)

I replaced the rear derailer on my bike after Schwinn sent it to me. The old one had a bent piece. I can't shift onto the largest 2 rear gears. I set the shifter to the lowest setting, but the chain ...
0
votes
3answers
11k views

What do I need to know about fitting new wheels on a bike?

My girlfriend has had the wheels stolen from her bike. I'd like to replace them, but we're working with a limited budget so I'm going to do the work myself and source the parts second hand. I've done ...
10
votes
10answers
26k views

While pedaling standing up, bike crank gives in as if shifting, what is causing this?

While standing up and pedaling, the cranks give in as if shifting. It seams like I am shifting down, but my hands are off the shifter, almost like the chain is skipping a link. I took it to a bike ...