0
votes
1answer
50 views

Help with pairing the right headset to a new 3T fork

I recently purchased an Aventon Mataro (http://aventonbikes.com/track/) frame and a 3T Funda Pro with tapered fork (1 1/4' - 1 1/8' 1.25 ). I've been trying to figure out which headset I need to fit ...
1
vote
1answer
542 views

How can I fit a tapered fork to a 1 1/8 semi-integrated/zero stack head tube?

I have a 2004 Giant VT frame with a zero stack / semi-integrated headset. It currently takes a straight steerer threadless fork. Is there any type of headset I can put on so I can fit a tapered ...
3
votes
2answers
258 views

Gap between lower headset cup and fork. Is this likely to be a problem?

Yesterday I had a headset and fork fitted by my LBS. Lacking the specific tools or knowledge, I thought it better to leave this job to a professional; as a consequence of my inexperience, however, I ...
0
votes
1answer
91 views

Missing a part from an internally threaded steer tube

I recently obtained and then disassemble a Kink Co. BMX. It had a threadless headset. Unexpectedly, instead of having a star nut inside the fork's steer tube, the steer tube was internally threaded ...
3
votes
2answers
241 views

Trying to build a bike, confused about fork/headsets/compatability

I have a fork with a 1" steerer tube, and a frame with a 1.5" head tube. The steerer tube is slightly short, and when inserted into the frame, is flush with the top of the head tube. The fork is ...
3
votes
1answer
880 views

Is it possible to replace a 1 1/8 steering tube with a 1"?

I have a 94 Giant ATX. Threaded 1 inch steeering tube. I need a shorter stem, and would also like to install a suspension fork. Is it doable? Could I take a modern suspension fork, heat the crown, ...
1
vote
2answers
1k views

Where can I get a new steer tube or 1 1/8" 6061 Aluminum Rod Stock?

I have an Anti-Gravity fork that features a removable steer tube, but it is a threaded fork. Where can I buy a threadless steer tube to clamp into it to convert it? All I can find are threaded steer ...
3
votes
3answers
1k views

Can I use normal grease for a car on the surface of carbon bike?

Helo Guys, I want to know your experience about carbon material and grease Can I use normal grease with carbon ? I want to put grease onto fork and stem.... Or WD-40 or silicone penetrant would be ...
1
vote
2answers
1k views

Installing a compression plug

I am currently building a bike up. I have a carbon fork, with a carbon steer tube, and I have to install it using a compression plug. I picked up one of these this morning: ...
3
votes
2answers
424 views

What are early signs of failure in forks/stem/handlebars?

I ride an SE Lager. In the past year, the following components have worn out or broken Front chainring Rear cog Rear freewheel Chain Seat (one of the bars snapped off) Many, many spokes Wheels ...