2
votes
1answer
99 views

Why is it important to keep bearing sets when greasing a campagnolo hub?

In almost all cases where hubs are regularly serviced, bearings don't need to be replaced. The general consensus though is to replace bearings after so many thousands of kms. Many posts on the web say ...
3
votes
2answers
182 views

Maintence on Mavic 500 hub without Mavic 670 tool

I have a beloved but well used front wheel built around an old Mavic 500 hub whose bearings are finally starting to give up the ghost. If you hold the axle and spin the wheel you can feel it grind ...
1
vote
1answer
525 views

Could I have damaged the bearings/cone when replacing a tire? Front wheel wobbles side to side

Last evening I installed new tires on my bicycle. The front wheel now wobbles side to side. I notice a small movement about 1-2 mm near the hub/axle cone. I checked to see if the skewer is all the ...
4
votes
1answer
397 views

Should cassette “wiggle”

Recently My freehub broke and so I removed the cassette to replace the freehub and noticed, whilst off the bike, 4 of the remaining bolted together 8 sprockets wiggled (4 wiggled together but ...
3
votes
1answer
2k views

How do I clean the inside of a freehub?

I didn't know any better and I let degreaser drip into the freewheel body of my Shimano FH-RM65. Now it makes a terrible retching noise when it rotates. How do I clean the inside of this thing? ...
3
votes
3answers
8k views

What tool is needed to remove a Shimano HG-50 freewheel?

What tool is needed to remove a Shimano HG-50 freewheel from the wheel hub? It looks like a 12mm or 13mm Allen key. Will this do it or is there some detail I have missed?
5
votes
6answers
7k views

7-speed MTB cassette on 8/9-speed wheel hub, where does spacer go?

Sheldon Brown says "Add a 4.5 mm spacer before installing a 7-speed cassette on an 8-, 9-, or 10-speed hub", but doesn't seem to show spacer placement in any picture. My direct experience is that the ...
6
votes
4answers
2k views

Trouble getting the right cup and cone hub adjustment

I have a pair of Shimano XT wheels and recently had issues with the hub on the rear wheel requiring new cones and bearings. These were fitted carefully but I've had issues getting the right adjustment ...
10
votes
3answers
5k views

do DT Swiss 240 hubs need proprietary tools to maintain them?

the bearings in my DT Swiss 240 hub appear to be shot, I have the toolkit for and am used to maintaining Chris King hubs but I wonder if I have to get special proprietary tools for the DT hubs as ...
13
votes
6answers
19k views

How often should I grease and repack my hubs and bottom bracket?

I am commuting 7 miles a day (round trip) in all weather in New England (temperate, moderately wet climate, cold winters). Overall I am putting about 1000 miles per year on my commuter bike, a 2009 ...