Tools, parts, techniques, and procedures to keep your bike in working order. MAINTENANCE is not the same as REPAIR, a separate tag. Maintenance is what one does on a regular basis. Repair is what one does only when something is broken.

learn more… | top users | synonyms (2)

2
votes
1answer
44 views

Is it a good idea to sand off the rotor when exchanging disc brake pads?

During operation, disc brake pads cut grooves into the rotor. When replacing the pads with new ones, would it be a good idea to smoothen the rotor with sandpaper(e.g. grit 200 then grit 800)? What is ...
3
votes
1answer
169 views

Please help me identify my bike

I have recently bought a house and found this bike in the garage. I'm currently thinking of giving it a full service, but I'm not a super expert on it and therefore I'd maybe like to take it to a ...
2
votes
1answer
1k views

Is it possible to run standard mechanical shifting on a Scott Foil Premium frame?

The Scott Foil Premium is the highest end frame available from Scott Sports, and it is designed to run an electronic drive train, routed internally. The original reports were that this frame would be ...
1
vote
1answer
128 views

How dirty should the chain and the cogs be before I should consider cleaning them?

I'm new to bicycling and have been riding for a month or so. I just saw a few questions here regarding cleaning of the chain and thought "whoa, I should clean the chain". How dirty (visually) should ...
9
votes
10answers
2k views

Where can I get some rags?

As I'm getting into the habit of cleaning and maintaining my bike more often, I am burning through my stockpile of rags. Up until now I have been using worn-out clothes as rags. I am going to run out ...
1
vote
1answer
56 views

Cheap, effective degreaser recommendations?

Maybe it's just me, but most of the commercial degreasers sold in bike shops seem pretty expensive for what they do. While they work well for lightweight grime, especially when used regularly, they ...
0
votes
0answers
26 views

orientation of non rotating washers (Nexus 8-Speed Internal Hub)

The anti-rotating washers on my Nexus 8-speed internal hub axle are opposite to what every service manual I've seen suggest they should be. In particular, the yellow washer is on the left side and ...
0
votes
1answer
100 views

What exactly happened to my rear derailleur?

I had installed my front derailleur and was adjusting the high/low when I noticed my rear derailleur was hitting the spokes of my wheel. Suddenly, I saw a screw pop out and then my derailleur popped ...
0
votes
0answers
51 views

Where to buy 2005 Shimano 105/Ultegra brifter hoods?

I have a 2005 Trek 1500 WSD road bike with original Shimano 105 STI brake/shifter levers. I'm looking for replacement hoods for the brifters because the originals are wearing out. I believe the ...
13
votes
6answers
17k views

How often should I grease and repack my hubs and bottom bracket?

I am commuting 7 miles a day (round trip) in all weather in New England (temperate, moderately wet climate, cold winters). Overall I am putting about 1000 miles per year on my commuter bike, a 2009 ...
0
votes
1answer
51 views

Are there any suitable alternatives to alcohol/brake cleaner for cleaning brake rotors?

Alcohol and brake cleaner seems to be the recommended options for cleaning disc brake rotors. I don't have any of that available currently, so are there any suiltable alternatives to them that can be ...
6
votes
6answers
1k views

How do I keep a bike feeling “new”?

I think there is a subjective feeling of "newness" to a bike which is straight out of the box. What is it mechanically and aesthetically that creates that? What can I do to prolong, preserve or ...
5
votes
6answers
234 views

What can I use for a DIY cable end?

I am in a pinch and need something to crimp onto the end of my brake cable to stop it fraying. There aren't any hardware shop's nearby and its a long way to the nearest bike shop. Any household ...
2
votes
2answers
92 views

I need to change my fork after having an accident with my bike

I need help as I need to change the fork for my bike (Ridgeback Speed 2013 Womens Hybrid Bike) I live in London and I went to few shops but in all of them they need to order the fork and it will cost ...
9
votes
3answers
917 views

Should or can I (car) wax my frame?

Having spent the whole summer taking a bike apart, painting it and now in the process of building it again, I was thinking about waxing it. I want the finish to last as long as possible, after all, ...
10
votes
2answers
1k views

Disc Brakes: Resurface your Pads?

Is resurfacing the brake pads in disc brakes (hydraulic or mechanical) necessary? If so, what would you use to do this - medium sandpaper? I spoke to one mechanic while shopping for a bike, who ...
2
votes
1answer
142 views

problem in gear shifting

I'm using a 21 speed bicycle,the problem is I'm unable to shift the chain to the smallest derailleur(rear)...the shifters are thumb press type there's no problem in pressing the shifter...when ...
0
votes
1answer
262 views

Rear V-brake pivots (cantilever studs) asymmetrical on Specialized Hardrock XC 2004 - how to fix?

This is a bit weird question. I bought a Specialized Hardrock XC used bike cheaply on e-bay. It had no front brake and the rear v-brake had different arms and was very dodgy. I thought I would able to ...
3
votes
3answers
161 views

What kinds of tools do I need to do bike maintenance, e.g. adding a rack?

I just got a new Trek 7.2 for commuting and getting around town. It's a great bike but I want to add some stuff to it like a rack. I am fairly handy and have more or less a full toolkit in my ...
4
votes
2answers
160 views

How to correctly align “be seen” lights

My "be seen" bicycle light is bar mounted and has to be reattached every time I jump on the bicycle, due to theft risk. How do I determine when it is correctly aligned? In particular how are "be ...
22
votes
2answers
3k views

What's stopping you from pedalling backwards?

On the BMX bike I have, pedalling backwards moves the chain but doesn't drive the wheels of the bike backwards like you would expect it to. Why is this?
0
votes
2answers
78 views

How do you check your road bike tires for wear? [duplicate]

What is the best way to determine if your tires need to be replaced?
3
votes
3answers
670 views

How to correctly align “to see” bicycle lights?

My "to see" bicycle light shifts out of position. While I need to fix it (fork bridge mounted dynamo), how do I determine when it is correctly aligned? In particular how are "to see" lights ...
2
votes
3answers
104 views

Why does my bike crank creak and come loose?

I recently purchased a Trek FX 7.2 and about 2 weeks after purchase I was riding and I noticed a creaking sound and shortly after the crank fell off. I brought bike back to where I purchased it and ...
1
vote
1answer
107 views

Front derailleur adjustment

I need some advice on properly adjusting the front derailleur (shimano -tourney) of my bike. I did watch youtube videos and stuff on the internet but was not able to adjust it properly. When I ...
-1
votes
1answer
349 views

V-brake mount for caliper brakes

Is there an addaptor or mount that uses your V-brake mounts to allow a new fork without disc mounts that i have, to enable it to use caliper brakes, i try to avoid geting new brake levers, i figure an ...
4
votes
0answers
99 views

Fixing hydraulic disk brakes, what to check first?

I have a 10-year old bike, fitted with hydraulic disk brakes. The bike has been actively used for around 4 years only though. Recently, my brake levers started to have more and more "play" before the ...
1
vote
1answer
89 views

Maintence on Mavic 500 hub without Mavic 670 tool

I have a beloved but well used front wheel built around an old Mavic 500 hub whose bearings are finally starting to give up the ghost. If you hold the axle and spin the wheel you can feel it grind ...
17
votes
10answers
3k views

How much does bike price correspond with maintenance needs?

In this question (with this answer) I asked about a commuter bike, which is to be ridden 40 km every weekday, in the city. And apparently for this scenario I can choose either of two possible kinds of ...
1
vote
1answer
233 views

Can you take apart rear derailleurs, and how do you put them back together again?

I recently took apart my rear derailleur as it was on a 10 year old bike and really old and stiff. So I thought I would unscrew both jockey wheels and clean them, they had a silver bit either side, ...
1
vote
2answers
113 views

Which rim tape for 700x28 tires?

Which rim tape should i use for 700x28 tires? I can only find 700x17 or 700x14... I just measured my 26" and the (outside) base of the rim is 24mm... and i used rim tape that is 20mm wide... it ...
8
votes
3answers
4k views

Fixing noisy V brakes

My V brakes make a lot of noise when I brake!! I am annoyed by such noise not to mention the pedestrians. My Mechanic said that it will not make those noise after using for couple of days, but it is ...
4
votes
2answers
6k views

Which lubricant/grease to use for ball bearings?

A little mishap happened today during cleaning my bicycle. I tried to take off the sprocket wheel for easier access, but instead I opened the lock nut of the hub (cassette type) and the balls came ...
13
votes
7answers
2k views

Why would I need a torque wrench for a bicycle?

I was rather surprised to find a question about choosing a torque wrench on this site. I haven't cycled for years, but many years ago when I actually cycled I would do with a set of ordinary wrenches ...
4
votes
2answers
3k views

What's the performance difference between a front-load and top-load bike stem?

I recently bought a bmx and after doing a few tricks on it, the front-load stem became loose enough for the bars to slide forward (they rotated towards me about the point the bars were connecting at ...
1
vote
1answer
89 views

if you replace the front gear system do you need to replace both the rear casette and the rear derailuer or neither

I've been given an old bike from the road which has gears where you can't tell what gear the lever is in (there is no number) just a lever in one of three positions or seven for the back). I am ...
5
votes
2answers
2k views

Brake callipers not long enough to allow adjustment of pads

I upgraded the standard Tektro brakes on my SE Lager to Shimano 105s. The braking performance is vastly improved. I also have Charge Plug wheels, rather than the stock wheels. However I've noticed ...
0
votes
1answer
109 views

Partially disassembling Sticky Shimano STI shifter for service

There are a few questions floating around regarding sticky STI shifters and the standard procedure seems to be to flush with a load of WD-40 and relube with aerosol grease or similar. My set is ...
17
votes
7answers
5k views

Does the plastic cap on a Presta valve serve any purpose once fitted to a rim?

I can see the use of the valve cap on a Presta valve when the tube is still packaged (it obviously stops the valve puncturing the tube), but does it do anything except look pretty (or not) once you've ...
0
votes
0answers
40 views

Planet Bike speedometer won't reset

I have a planet bike speedometer and after the winter season it seems that it is no longer functioning. It will come on when the bike starts to move but I cannot reset it and it seems to be frozen on ...
5
votes
5answers
364 views

When to lube a chain?

Should a chain be lubed each time after riding in the rain*? What about a 100km mudride (occasional water up to the hubs)? Should I stop in the middle of the ride to re-lube the chain? If so, is it ...
16
votes
4answers
669 views

Optimal Maintenance Schedule

It is forecast to rain this weekend so I was thinking I would drop a tarp down over my living room floor and give my bikes a bit of a tune up. Question What maintenance needs to be done on your ...
3
votes
3answers
183 views

maintenance schedule tracking software

Can't seem to find software to track maintenance i do / is due on bike(s). I just want to enter when i changed the chain/casette on bike A, then track how many km ive gone with it. Distance could be ...
39
votes
3answers
8k views

Can I use WD-40 on my bike?

Is WD-40 really bad to apply on bikes? I was told so but still see people doing that. Also I saw WD-40 launching their new products of bike lubricant and degreaser. Did anybody try those?
1
vote
3answers
134 views

How can I get a bike mechanic certification/where can I learn to be a bike mechanic?

I'm interested in becoming a bike mechanic in Melbourne, Victoria, Australia. I'm hoping there's an industry body which runs courses to certify bike mechanics. I'm really hoping it's not just ...
0
votes
2answers
148 views

How to measure chainring / cog wear?

Other than attempting to estimate whether a chainring or cog is worn and needs replaced by eyballing it, is there any way to measure the wear on chainrings or cassette cogs so you can determine ...
4
votes
1answer
280 views

Rotating 2 chains on one cassete

I clean my chain on the bicycle, mostly because taking it off for a bath, drying, etc seems to take more time than I have. But maybe I could use 2 chains in rotation, I would take one chain off, ...
1
vote
3answers
281 views

Cycle tyre and tube burst

I pumped my cycle front tyre to 105 psi (700*23c) 5 days back and cycled some 60 km on the same day without any punctures. Afterwards I parked the cycle in my bedroom for the last 5 days (due to ...
5
votes
5answers
7k views

7-speed MTB cassette on 8/9-speed wheel hub, where does spacer go?

Sheldon Brown says "Add a 4.5 mm spacer before installing a 7-speed cassette on an 8-, 9-, or 10-speed hub", but doesn't seem to show spacer placement in any picture. My direct experience is that the ...
10
votes
2answers
738 views

Is it harmful for a hydraulic brakes bike to be put upside down

I heard somewhere that bikes with hydraulic brakes should not be put upside down. If they are, 15 minutes should be allowed, before the bike is used. Is there any truth in this? What process could be ...