Tools, parts, techniques, and procedures to keep your bike in working order. MAINTENANCE is not the same as REPAIR, a separate tag. Maintenance is what one does on a regular basis. Repair is what one does only when something is broken.

learn more… | top users | synonyms (2)

0
votes
2answers
122 views

back tire keeps going down

I have just bought a new bike and had it about a month now. I don't really know much about bikes but I do know how to repair an inner tube. I have had one puncture and just bought a new inner tube. ...
1
vote
1answer
71 views

How can I tell where the damage is in the hub?

I am pretty new to bicycle maintenance. I've replaced brake cables, and patched tubes, but not much else. This week my plan was to clean up my back hub, because the wheel hadn't been turning as ...
1
vote
1answer
115 views

How do I reassemble the rear gearing after fitting new tyres?

I have a Raleigh maybe 8 years old with shimano 15 gears. How do I reassemble the rear gearing after fitting new tyres? Everything seems to be in correct position but a small bolt with captive nut ...
0
votes
1answer
60 views

Front and Rear speed shifters aligment guide

How to align the front and rear speed shifters ? My chain dropped from the front chain ring, and I put it back on the first gear I found, then the rear one fall off, and I put the chain back on the ...
-1
votes
1answer
514 views

V-brake mount for caliper brakes

Is there an addaptor or mount that uses your V-brake mounts to allow a new fork without disc mounts that i have, to enable it to use caliper brakes, i try to avoid geting new brake levers, i figure an ...
1
vote
0answers
23 views

Fork damper circuit reconditioning

I have a rockshox Dart II from 2007. I have recently rebuilt it for the first time in 9 years as it had basically locked up, and not so surprisingly given its neglectful treatment, its still not ...
1
vote
0answers
102 views

Refurbishing mountain bike - left standing for couple of years

I've a Marin Rocky Ridge (2007) that I'd like to give a bit of an overhaul/refurbish as it's been left standing for two years or so. I'm just looking to know where would be common areas that would ...
1
vote
0answers
160 views

Lowrider style bent forks techniques

Would a 24 inch bent fork fit on a 20 inch frame? Is there even a 24 inch fork? Would a 26 inch fit? Also if it doesn't fit in could I just add to the 20 inch - would you be able to extend it making ...
0
votes
0answers
43 views

Can't find right headset adjustment

After a complete tear down and reassembly I can't seem to find the right tightness adjustment for my threadless fork / headset. If I loosen it to the point that the front fork turns freely, there's ...
0
votes
0answers
38 views

Disc Rotor Alignment Mavic Crosstrail

I have a disc rotor alignment question you maybe can help me with. I have a Canyon Nerve AL+ 8.0 that's been working nice until the front wheel got stuck on the brake. First I thought it was a brake ...
0
votes
0answers
28 views

Cone size for Shimano Type D on Schwinn Cruiser

What size wrench do I need for the rear hub on my Schwinn cruiser? It is a Shimano Type D. Also, what grease is recommended that I might be able to by locally. Thanks to all.
0
votes
0answers
101 views

orientation of non rotating washers (Nexus 8-Speed Internal Hub)

The anti-rotating washers on my Nexus 8-speed internal hub axle are opposite to what every service manual I've seen suggest they should be. In particular, the yellow washer is on the left side and ...
0
votes
0answers
60 views

Planet Bike speedometer won't reset

I have a planet bike speedometer and after the winter season it seems that it is no longer functioning. It will come on when the bike starts to move but I cannot reset it and it seems to be frozen on ...