2
votes
5answers
102 views

How can I tell if I have properly patched a tube? (specifically a 2" mt. bike tube)

I normally swap out a the tube on the trail if I get a flat and then patch at home. So that leaves me with a patched tube ready to put in a tire and I'd like to test it without having to swap out a ...
3
votes
4answers
576 views

“Quick Fix” Tyre Repair Spray Cans

I saw this in my local supermarket, as they are having a cycling event on at the moment. I was thinking this would be quite useful if I had a puncture away from home, the car or bike repair shop, or ...
1
vote
2answers
153 views

Why has my ride changed?

The bike is a Specialized Camber 29, about five months old, from a shop about 220km away. Something feels different in my ride, and I'm wondering what it is. the rear goes sideways in sand much ...
2
votes
1answer
501 views

What does vulcanizing solution in patch kits consist of? Can I buy it?

I have a pile of old patch kits for inner tubes that are complete except for the little tube of "vulcanizing solution" that comes in patch kits. With time, these tubes crack, or have a cap fail to ...
1
vote
3answers
469 views

Cycle tyre and tube burst

I pumped my cycle front tyre to 105 psi (700*23c) 5 days back and cycled some 60 km on the same day without any punctures. Afterwards I parked the cycle in my bedroom for the last 5 days (due to ...
2
votes
3answers
135 views

Why would each patch produce a new leak before resintalling tube?

I got a puncture in my tube (size 700c x 23c, Kendra, came with bike) and applied a vulcanizing glue and patch, then checked it. Before reinstalling the tube, there was now a new leak right next to ...
4
votes
2answers
105 views

Why would tube patch sometimes peel off with backing?

Sometimes, when patching a tube, the newly placed patch will peel off when removing the backing. Sometimes I have this problem and sometime I don't and I'm not sure what the difference is. Is it the ...
2
votes
3answers
949 views

Best way to patch road bike tubes

I've scoured the internet for this answer, as I recently just tried to repair a tube on my Purefix fixed-gear bike which I assume uses tires and tubes similar to road bikes, as the tire size is ...
3
votes
2answers
4k views

Deformed/uneven/bumpy wheel/tire/tube, how to diagnose or repair?

My bike has a deformation in the rear wheel, almost surely not due to the rim. At some point the tire has a "valley", causing it to bump instead of rolling smoothly. I'd like to understand if I have ...
4
votes
2answers
207 views

How many times to patch a tube before dumping? [duplicate]

Related: Patch or replace tube? This video asserts that: A properly patched area of a tube is stronger than intact tube area Never patch a tube more than 3 times Those are seemingly ...
4
votes
2answers
1k views

How to Patch a Bike Tube?

Related (but more general): What steps should I follow to patch a tube? I have done this more than a hundred times, but am still not sure what are the correct steps. Here they show to put glue ...
3
votes
1answer
103 views

Rim cement as a replacement for rubber cement

Can I use aluminium rim cement for patching flat tire instead of using rubber cement?
3
votes
2answers
2k views

Can I use a shock pump to inflate a tube?

I know that shock pumps are meant for high pressure applications so that they can withstand high pressures needed by suspension shocks. However, can I use a shock pump to inflate my tire in a pinch ...
4
votes
3answers
2k views

how to repair large holes in inner tubes

I find that any hole, cut or tear larger than a pinprick is impossible to repair with normal patches because they are too soft. Even a 2-3mm slit will cause the repair patch to balloon out and burst ...
10
votes
7answers
16k views

When should you replace tires after getting a flat?

A nail punctured my rear wheel tire today while riding. My question is, how do you know if you need to replace a tire or simply repair it with a tube repair kit? The hole looks pretty nasty. The cap ...
3
votes
3answers
2k views

Best practice for patching snakebite pinch flats on skinny tubes

So, I tend to run 700x23c or 700x25c tires on my commuter bike. Sometimes I'm lazy and forget to check the air pressure and inevitably get a pinch flat when I hit some stationary object, pothole, or ...
1
vote
3answers
477 views

Where is the proper location to measure the tube size?

I need to replace a tube in my bike. I know there are many tire sizes. I bought 26', assuming that my bike was that size, and realized when I got home that I didn't even know where to measure from. ...
13
votes
9answers
9k views

Patch or replace tube?

Is it worth patching a tube on a mountain bike, or just replace it with a new one? There are a lot of 1/2" - 3/4" thorns here in Texas, and I use 26 x 1.95 tubes. Any particular patch type/brand ...
21
votes
10answers
5k views

Do glueless tube patches work as well as glue ones?

Quite a few years ago I tried some glueless patches for repairing my punctured tubes while out on the road, and found that they rarely stayed on for very long. I know that technology has advanced a ...