0
votes
2answers
71 views

Shimano 105 brifters - rear shift jumps multiple gears

I have a Specialize Roubaix that's about 10 years old with the Shimano 105 component set. I've started to develop a problem in the rear derailer where when I shift to a higher gear/smaller cog, the ...
0
votes
2answers
106 views

Can I change my 7-speed rear derailleur to an 8-speed?

I bought a 2013 Cannondale Quick 6 Hybrid for my daily commute almost exactly a year ago, and I'm looking to give it some upgrades. It currently has a 7-speed Shimano Altus derailleur, and I was ...
0
votes
2answers
114 views

Fixing broken STI shifters - plastic gear cable surround

As pictured, after knocking over the bike I've broken one of the plastic surrounds where the gear cable enters the front derailleur shifter. Shifting between the lower two chainrings still works, but ...
6
votes
1answer
90 views

Front derailleur rubbing against chainring

I'm trying to fix up my old (1999) Trek 4500, and I've run into a snag while adjusting the front derailleur. It's a Shimano FD-CT92 (bottom bracket mounted E-type), and it's rubbing against the ...
2
votes
1answer
88 views

Replacement Brifters for a shimano 105 2x10

I have a 2009 Specialized Allez Sport C2. It came with shimano 105 components all around. the left hand (front) shifter recently broke, and will no longer hold a position. I can reach down and ...
2
votes
2answers
407 views

Where to buy 2005 Shimano 105/Ultegra brifter hoods?

I have a 2005 Trek 1500 WSD road bike with original Shimano 105 STI brake/shifter levers. I'm looking for replacement hoods for the brifters because the originals are wearing out. I believe the ...
1
vote
1answer
72 views

Chain brushes derailleur

I just got my ever first road bike, Revenio 3.0. I'm so excited. Already got my ever first road bike injury as well - those damn cleats are hard to unclip, springs on those shiny new pedals are too ...
3
votes
2answers
278 views

Are Claris(ST-2400) shifters drop-in replacements for St-2300s?

I've got 2300s on my bike. I don't much like the little thumb levers. I'd like to upgrade to Claris shifters, but I need to minimise the costs. Can I just change the shifters? They're both 8 speed ...
0
votes
1answer
212 views

Partially disassembling Sticky Shimano STI shifter for service

There are a few questions floating around regarding sticky STI shifters and the standard procedure seems to be to flush with a load of WD-40 and relube with aerosol grease or similar. My set is ...
0
votes
1answer
163 views

Replaced faulty Shimano twist shifter but front derailleur still won't catch 3rd

I have one of the ubiquitous Wal-Mart-sourced Chinese Kent bikes, badged as a "GMC Denali." It came with the Shimano RS41 3x7 twist shifters. The front shifter got to where it would not physically ...
0
votes
1answer
2k views

RevoShift Friction: shifting to the largest gear takes a lot of force?

My wife's bicycle has Shimano Revoshift shifters, and while the right (rear) one works fine, the left (front, Friction) has been problematic for a while. Originally, when we bought the bicycle, the ...
3
votes
1answer
2k views

What is a shimano ispec shifter?

I know what a shifter is but I could not find a definitive answer on what an ispec shifter is or how is it different from a regular shifter. For example the 2014 shimano deore groupset says it has ...
3
votes
1answer
479 views

Shimano 9 speed shifters

I have bought myself a Shimano Deore M592 set without shifters. I am now in the process of getting them as well but am not sure if I can put any 3/9 speed shifter on it. Do I only need to take care ...
1
vote
1answer
911 views

How to reassemble a Shimano Alivio Shifter

I need a diagram on how to reassemble a Shimano Alivio Shifter. I just can't seem to get it right. I even disassembled the other shifter to see how it all fits together and now I can't get it ...
1
vote
2answers
1k views

Are Shimano R440 road flat bar shifters compatible with a mountain bike front derailleur?

The Shimano shifter flat bar series have the same cable pull length than the mountain bike shifters. Is this series compatible with a mountain bike front derailleur, Deore, for example?
2
votes
0answers
218 views

My left STI shifter has 5 positions for a double crankset?

I'm in the process of installing my Shimano Tiagra left shifter for the front derailleur on my double crank and I'm a bit confused, the indicator shows it has 5 positions for a crank with only 2 ...
5
votes
4answers
6k views

How to repair sticky Ultegra shifter

I have Ultegra 3x9 shifters and derailleurs that were installed just a couple months ago. I purchased them on eBay and although they were new, they had been sitting in inventory for a couple years so ...
3
votes
1answer
295 views

Nexus shifter with Alfine hub

Is it ok to use a Nexus 8 speed grip shifter with an Alfine 8 speed hub? The Alfine shifters seem to be all trigger shifters is that correct?
2
votes
1answer
1k views

Replaced Shimano Bottom Bracket, now front derailleur won't shift to largest gear

OK, so in my quest to get my old Trek 7000 ZX MTB running again after a long retirement, I am having an issue with replacing the bottom bracket. The bike came with a Shimano LP25 that is marked BC ...
4
votes
1answer
4k views

Upgrade Shimano Sora shifters to 105

I want to upgrade my 3x9 Sora shifters to 3x10 105s. However, looking at the Shimano Compatibility Chart, it appears to indicate that I'll have to replace my front and rear derailleurs in addition to ...
2
votes
2answers
4k views

7 speed to 8 or 9 speed cassette change

this is my first time here and i am new in the bike sport. I have a mtb for a month now and i usually use it for road trips with some dirt intervals. It has a 7 speed shimano cassette (14-34) and on ...
3
votes
1answer
333 views

Anyone know the pull ratios of Zee 10sp and XT 9sp Mechs?

I'm putting a bike together from a load of spares and I'm having difficulty getting a shifter and derailleer to play well. I think the problem is the Zee mech. Does anyone know the pitch/pull ratio in ...
3
votes
1answer
324 views

Can I use Shimano trigger shifter with my X3 SRam gears?

My bike has SRam X3 gears and a grip shifter. I'd like to change for a trigger shifter. In the bike shop where I bought it, they say that I can change for a Shimano shifter (they don't have SRam). ...
1
vote
3answers
3k views

Front Derailleur Not Working

I recently bought a new bike off of BikesDirect. http://www.bikesdirect.com/products/windsor/wellington2_IX.htm However, no matter what I do, I can't seem to get the front derailleur to do anything. ...
1
vote
1answer
626 views

Can I use 10-speed Shimano STI shifters with a 9-speed drivetrain?

I need to replace Shimano 105 STI shifters on a 9-speed road bike which was damaged in an accident, however there are few places that still stock 9-speed Shimano 105 STI shifters. Can I use the ...
4
votes
1answer
370 views

Shimano Sora shifter having trouble in the snow

So today is the first day of snow here in Norway, and I had prepared well for this day. My Giant Cyclocross has new spiked tires and i've done a check on all components, they are ready for the ...
2
votes
2answers
5k views

What shifters are compatible with shimano 9-speed?

I haven't ridden in anger since around 2003. I have two bikes which I am trying to return to a roadworthy state. Each has a non-functioning right hand shimano shifter. Racing bike: Ultegra 6500 ...
1
vote
1answer
774 views

New shifters: is Acera SL-M360 a good buy and how much better is SL-M310?

I was going to buy the Shimano Acera SL-M360 (but now the shop only has the SL-M310 ones), so I wanted to double check if it's what I'm actually looking for. I just want them to last long and do their ...
3
votes
2answers
4k views

Can you use a 8 speed Shimano shifter with a 7 speed cassette?

Want to use a 8 speed shifter on a 7 speed cassette. I saw this question, but I am unsure if this would work, since I believe the spacing is the same between a 7 and 8 speed, the length is just not.
5
votes
1answer
3k views

Replace Ultegra 6600 STI lever

I need to replace my Ultegra 6600 right hand shifter as the ratcheting system is gone. The rest of the groupset is all the same 6600 series. I am having a hard time sourcing just a right hand side ...
1
vote
3answers
1k views

Ultegra 9-speed brifter upshift problem - beyond WD-40?

I have a 2000 Ultegra 9-speed right/rear brifter that does not "release" the cable properly. My initial search on this problem suggested that this could often be cured by flushing with WD-40. So ...
1
vote
2answers
943 views

Is it possible to reverse cable direction in Shimano M770 shifter?

I tried to set up the perfect shifter + derailleur. For the last part it is better (for me) to have low-normal version, because reducing gears is essential for me (I bike mostly within city). So I ...
3
votes
2answers
835 views

Electra Shifter (Revoshift) is hard to turn

My wife has a hard time turning the Revoshift grip on her Electra Townie 7D due to arthritis issues in her hands. Is there a way to help with this issue?
4
votes
4answers
8k views

Shimano Revo Shift Gives No Clicks

I have a problem with my shifter. My bike is using Shimano Revo Shift(gripshift) RS-35 (see my picture). The one shifting the front derailer (the left shifter) does not click when I turn it but it ...
0
votes
1answer
626 views

swap Shimano Alivio gear indicator for cover plate

I want to move my brake levers and gear shifters around a bit. The problem is my gears (Shimano Alivio, bought 4 years ago) have a large gear indicator on it. This is meaning that either the brakes ...