The rubber attached to the rim of your wheel. Flats, changing tires, selecting tires, etc.

learn more… | top users | synonyms (3)

4
votes
2answers
411 views

What is the largest hole a tire can bear before replacement?

Saw this question today. The tire in question has a 2cm long hole on the inside, from a knife. I sometimes get puncture flats from e.g. glass. Never as big as 2cm. Usually if they're less than ...
3
votes
2answers
887 views

Can outer tyre (casing) punctures/cuts be fixed?

My flatmate got his tyre stabbed. With a knife, it seems. (The bike was tied to a staircase railing in the building and was obviously in some maniac's way. Though there was plenty of room around. And ...
6
votes
2answers
1k views

Can oil/grease damage tires?

I've noticed a small puddle of light oil beneath the rear wheel of our Rohloff-equipped tandem. I'm told that a small amount of leakage is normal and I'm not worried about that. The issue is that a ...
5
votes
3answers
459 views

What factors influence the maximum tire pressure other than the tire itself?

On the tires of a bike, there is a label which shows the maximum allowed pressure for it. However, I am wondering if there are any other factors that affect the maximum allowed pressure in a tire? ...
1
vote
2answers
812 views

tyre size for a 28" bike, at the moment: 35C, is 32C too narrow?

since my tyres are a little old and won't make it much longer, I will buy new ones. At the moment I have Schwalbe Marathon 700-35C and I was thinking to replace them with a Continental Contact II 700 ...
2
votes
3answers
151 views

Tubeless fatbike setup, does valve choice matter?

I've got a pugsly setup as tubeless, running endomorph tires, typically I run between 8 and 12 PSI in the tires depending on the conditions. Is there a significant difference between performance of ...
1
vote
2answers
146 views

Continental 4Seasons vs 4000S

I am currently riding Conti GP4000S tyres, in 700x23mm version, inflated at 115 psi. The grip is great, the (light)weight is amazing. I have punctured twice with them (in 1500 km) which is more that ...
5
votes
1answer
5k views

What does the label on a tire mean?

I went to a bike shop for new tires. I did not know which tires fit on my bike, so I just showed them my bike. When I took a look at the new tires, there was a label at the side, which says: ...
1
vote
3answers
917 views

Tires for 28' city bike (622x19C) to reduce rolling resistance?

I've got a simple city bike that needs some new tires. The bike has been fairly hard to ride lately, and I would like to speed it up a bit. The rims are 28' 622x19C, the current tires are 47mm or ...
1
vote
1answer
861 views

Rear tire has started rubbing frame at one spot

Riding my bike within my suburban residential neighborhood, I felt a shock, like a snap although I don't think anything snapped, followed by a rubbing noise every few seconds. Pedaling and the brakes ...
0
votes
5answers
771 views

How can I repair a swollen tire allowing visibility on the inner tube (picture provided)?

I have a new problem on my bike which occured after patching my inner tube. Since I put the patch on, my tire is pushed out away from the rim near the intake valve (not near the patch). In the picture ...
15
votes
4answers
744 views

What to do with old tires?

I recently upgraded to puncture resistant tires on my road bike. The previous tires are old, but still usable. Is there any value to doing anything other than throwing them out? For instance, is there ...
2
votes
2answers
795 views

Can I damage a tubeless rim using a wire bead tire on it?

This question is very similar to Can I use a standard tyre on a tubeless rim? but while the answers there set out that it's possible I'd like to understand the risks of doing it. I recently saw a ...
7
votes
1answer
363 views

Water in my back tire

I commute 17 miles to and from work each day on a road bike, and I recently picked up a puncture. This was no problem. However, on my ride to work this morning it was raining rather heavily and there ...
1
vote
1answer
716 views

What inner tube do I need for this tyre?

Can anyone tell me what spec inner tube I need for this tyre? I discovered the one I'd previously bought didn't look fat enough when I got my first puncture with it the other day, now I'm in the ...
0
votes
0answers
48 views

gatorskin tyres [duplicate]

I wondered if anybody could shed some light? I am attempting to put 700x32c gatorskin tyres on to a hybrid rim but am really having trouble getting the last 15cm on to the rim. The tyres that I had on ...
5
votes
2answers
184 views

Is this rim safe?

The rim has a parting at the join: This is a brand new wheel, and I was wondering if this is a safe one. Could it split at the join?
7
votes
3answers
1k views

Could I switch tires on an MTB to tires with less friction if I mostly use the MTB in a city environment?

I thought MTBs were OK to use in the city but the friction from the tires seem to hold the bike back more than other tires would. I got a mountain bike (Scott) and it's less than optimal on flat ...
1
vote
1answer
203 views

Cross tires on a road bike

I want to buy a road bike for commuting, fitness, leisure, etc. and not for professional racing. However, because I live in a "wet" country, I would like to be able to change the tires into cross ...
0
votes
2answers
2k views

Life expectancy of a cycle tube and tire?

Can anyone please let me know the life expectancy (no of km or time period) of a cycle tube and tire? Let us consider different cycles (MTB Hybrid Roadbike) and different terrain (off-road slightly ...
4
votes
1answer
735 views

New 26“ inner tube different size to old 26” inner tube

The new 26" MTB inner tube is much bigger than my 26" wheel (and old 26" MTB inner tube). I don't understand why. How to shopcorrectly for new tube? The bike is 1990s Raleigh mountain bike. Edit: ...
0
votes
1answer
212 views

Puncture resistant 18" tires?

I need to replace the 18" cheap Schwalbe iMPAC Streetpac 47-355 tires that came with my Birdy folding bike with puncture resistante tires. I almost never ride on country roads, so thinner tires are ...
1
vote
2answers
501 views

Extend clearance for a 28mm tire

I tried upgrading to some 28mm but as you can see clearance is very tight. In some spots, the tire doesn't fully clear the brake (Tektro R350). The fork barely has enough clearance. Is it worth ...
1
vote
1answer
598 views

Is there a certain size tube for my tyres?

When it comes to fixing bikes, i'm not to crash-hot. I can clean grime, oil the chain and put it back on if it falls off. However, when it comes to the inner tubes I usually rely on someone else to ...
2
votes
4answers
2k views

Cheap alternatives to avoid tire punctures

If you head to Walmart and see the slime bike liners for in the tire to stop goatheads and small nailes from actually running the tire. Is there anything around the house or shed that can be used ...
6
votes
2answers
924 views

Tire slips off the rim when inflated to 8bar

I bought new wheels for my roadbike (shimano wh-rs80 which have c24 alu/carbon rims). I was mounting tires on them yesterday and inflated them to 8 bar (~116 psi). After a few moments (30 seconds or ...
11
votes
7answers
2k views

Is it possible to glue or patch tire sidewalls?

This morning I discovered that my commuter folding bike had a bad flat tire, and I ran out to buy a new tube, no problem. I didn't notice until after I'd changed the tube that the tire sidewall was ...
6
votes
1answer
2k views

Picking spare inner tube size

My daily rider is a Schwinn MTB with 26" wheels/tires. Specifically the tire size is 26x47/52. On the inner tube there's a label that reads 26 x 1.90-2.125. I'd like to purchase a few spare tubes in ...
8
votes
6answers
43k views

How to inflate a tire with a Presta valve?

My new bike has these thin tires with a type of valve I haven't usedbefore. I searched online and found out it's called a Presta valve, and it's pretty common and popular. I'm finding it annoying and ...
-2
votes
2answers
607 views

The lightest 26" mountain bike tire with minimum width of 2.3 [closed]

All mountain or xc application, wet or dry condition.
2
votes
1answer
232 views

MTB Tire performance

I have always ridden a Mountain Bike and lately I've lived with a strange question related to the tire I've been using. I use a pair of 26 x 1.95 CST Rush tires that are a great cost-benefit and found ...
3
votes
1answer
249 views

Switch to narrower rims on a hybrid?

Following up on my original wheel issues question, I went to see my local cycling store to tell them about my problem. I want to change rims and would like to have them support tires from 23 to 28mm. ...
-1
votes
1answer
397 views

Fork MTB clearance problem

I have a felt Nine comp. It is a 29er with rockshox forks. The clearance is poor with a continental rubber queen tyre. Is there anything I can do to increase the clearance? (we're talking 1cm, which ...
3
votes
7answers
8k views

Why do my tires keep losing air, even after having the tubes replaced?

I had a problem a few weeks ago where my tires were flat and needed air every time I took my bike out of the garage. I brought it to the local bike shop, and they replaced my tubes. This made a ...
2
votes
3answers
150 views

“wound” on the tire side

The other day I was stopped at a traffic light when I felt my bike moving slowly forward. Did not pay really attention, thought there was a slight slope, so hit the brake and voila. But it did not ...
2
votes
4answers
203 views

What steps should I follow to patch a tube?

I was wondering if I'm missing something when I patch my wheel, because I patched it yesterday and it had low pressure today. This is what I did: Released the air Used 2 screwdrivers to remove the ...
6
votes
8answers
7k views

How much of a difference will I notice going from a Mountain bike to a road bike?

I have a Mountain bike with 1.95 tyres on it. Most of the cycle path I take into work is fairly well paved/asphalted, I'm not going over any dirt tracks or anything like that although there is the odd ...
4
votes
2answers
218 views

What's the shelf life of tublar tires?

I have a set of tubular Continental Sprinter Gatorskin (28" x 22mm) that have been sitting in the box on the floor for close to four years. They look fine, but I'm worried that they won't last long ...
5
votes
3answers
547 views

When to change winter tires for bicycles

At work, we discussed when to change to winter tires for bicycles (and cars). We assumed that temperature was the key factor and I used a program (Mathematica) to check the mean temperature in ...
11
votes
3answers
1k views

Is it safe to ride on an unevenly bulging tyre?

Most of the tyre looks fine, true and straight but the section photographed shows bulging. The rim itself is true, is this safe to ride on?
13
votes
5answers
2k views

Least worn tyre: front or back?

Where should I put the least worn tyre? on the front or the back? This is for XC MTB. Thanks in advance.
6
votes
3answers
2k views

Do tubeless tires offer significant benefits for a cyclocross bike?

I've been using tubeless tires with great success on my mountain bike for a year or so, and the time is here to replace the wheels on my cross bike. I was thinking of getting another pair of stan's ...
1
vote
3answers
2k views

Can I replace the 32 mm tires on a Trek 7.3 with 35 mm tires?

When I bought a Trek FX 7.3 instead of the 7.2, the bike dealer told me that the tires were the same. They looked narrower, but I thought it was just that I was used to my other bike. I found out ...
3
votes
2answers
649 views

Sounds like there is stickiness on my tire, but there isn't!

I noticed starting yesterday my front tire has been making a strange sound. It sounds like there is a small piece of tar stuck to the front tire and it makes a faint noise of sticking and unsticking ...
1
vote
3answers
771 views

What makes one road tire have a less “bouncy” ride than another?

When I replaced my rear tire this week, I expected an almost intangible improvement in weight, rolling resistance, and grip. However, I have noticed a significantly less "bouncy" ride. The new tire is ...
9
votes
4answers
3k views

Does the inner tube affect the maximum PSI?

If I have road tires that have a recommended pressure of 110 PSI and maximum of 120 PSI can I safely pump my tires up to that level or does the inner tube effect the maximum? I currently have the ...
5
votes
4answers
7k views

Will a change from 26x2.10 to 26x1.95 tires improve speed?

If I change my 26x2.10 MTB knobbies by 26x1.95 slick tires, will I feel any difference on my speed on paved roads? or is it going to be the same? I am kind of confused about how much I should change ...
3
votes
3answers
1k views

Rear wheel sliding/slipping on turns?

When I take turns, my rear wheel is sliding to the outside of the turn. I'm riding a 2012 Norco Heart, brand new stock tires, single-speed. I'm not carrying much weight, or taking turns too tightly. ...
2
votes
2answers
393 views

Bicycle with 1 tire with Presta valve and 1 with Schrader valve

One simple question: I have a mountain bike that has 2 tires with schrader valves. I bought a new tube with a presta valve by mistake. Do you see any issues with replacing one of the tubes that had a ...
0
votes
1answer
136 views

Does my flat tire need to be replaced? [duplicate]

Possible Duplicate: How do I know when to replace my tires? The surface of my rear tire has become flattened as opposed to its original convex shape. I have about 2,000 miles on it. "It" ...