I have flipped over my hub to try out the fixed wheel for a change, I am finding it very difficult to keep balanced while attempting to ride backwards! Does anyone have some advice or is there any trick to learning how to go backwards?

  • How are you getting into the backwards direction? Are you starting from a dead stop?
    – dotjoe
    Dec 4, 2012 at 19:46
  • slowing down gradually from forwards and then trying to move backwards but falling over instead :)
    – wim
    Dec 4, 2012 at 22:11
  • 1
    @wim did you get anywhere with these tips? I'm dying to know!
    – PeteH
    Dec 5, 2012 at 10:15
  • I saw a nice video on that - youtube.com/watch?v=BxPA5BX_tNk&t=297s Good luck.
    – Michiel
    Oct 20, 2019 at 15:24

5 Answers 5


Bicycles are designed in a way that makes them very stable going forward, at the cost of being unbelievably unstable while riding backwards. The most common fixed-gear geometry (inspired in track racing) doesn't help a lot. As a comparison, BMX is a modality where riders usually ride backwards in half-pipes, but the bike geometry is very different.

What I tried to do (before giving up), and what I have seen people doing, is to try to ride backwards IN CIRCLES, perhaps lowering the saddle a bit to a more relaxed position. I don't think the clipless or toestraps are key here, but a lower gear ratio might be very helpful.

After you perform some circle attempts, you can try to switch sides. Trying to do it very slow aids to gain inside as to which movement you actually have to do, since this movement is very counterintuitive: when you are leaning SLIGHTLY to one side, you have to point the handlebar the opposite way, so that the bike will go under you again.

I could manage to go some 4 meters back when I was trying often, but with almost no control over the direction the bike was going.

Perhaps a good video to start (with interesting links on the sidebar) is this:

Hope this helps!

  • Gah, the bad old days when people thought it was fine to have 30+ seconds of title sequence in a video lasting less than two minutes. Oct 12, 2019 at 19:32

Flip it back to non-fixed and get the hang of rolling backwards (perhaps down a gentle slope) first. As others have said, the bike is designed for going forwards, so backwards is a real skill. So you've got two major problems - steering and locomotion.

Do you drive? Almost all non-4x4 vehicles are front-wheel steered and reversing any distance in a straight line is similarly tricky. If you've driven a rear-wheel steered vehicle, perhaps a tractor or a forked lift, you'll know that they can be really maneuverable in tight spaces but quite tricky to keep in a straight line when going forwards.

It is though all about practice. 10000 hours to be world class!

Once you can roll backwards unpowered, then try the rolling backwards with the fixed, you'll at least have conquered the steering problem, now you can mix in the locomotion.


From my experiences with going backwards(fakie) on BMX, the best way to learn is to find a small bank or quarter pipe, ride up it, and come back down backwards. This will give you that initial speed so you don't fall over right away. I imagine it'd be kind of similar on a fixed gear, expect that you can actually gain more speed by pedaling backwards. I think the roll out would be similar.


I actually just learned how to ride backward with a fixed gear bike and it is not that hard. Took me in total 10 hours to learn how to go in a straight line. (A little bit harder than fakie on a BMX because of the fixed gear )

From my experience it take 3h to already be able to go in a straight line for short distance 10M.

What I did:

Step 1 - Learn to keep you stability "On Place" without going forward or backward.

Step 2 - Learn to stop your forward momentum and keep your stability "on place".

Step 3 - Learn to go from "On place" to backward momemtum. (Which feet position feel more natural)

Step 4 - Learn to go from forward to "On Place" to backward.

Step 5 - Practice rolling backward with your feet on the ground.

Step 6- Practice rolling backward and putting your feet on the pedal (Hardest part)

Steap 7 - Practice the real deal and test your limit. (Angle before bike fall on ground etc)

Have an awesome day. Dan


Get some clipless pedals. Then, practice until you feel like you've been practicing all day, then practice some more. Continue to practice until you're successful.

  • 7
    How will clipless pedals help at this stage? Won't that just make me more likely to injure myself falling over?
    – wim
    Dec 4, 2012 at 1:59
  • 1
    For most people, entering and exiting clipless pedals is easier because you can adjust the tension for clipping in and out (as opposed to toe clips which are either in or out - you really shouldn't be riding without any toe retention! Safety!)
    – WTHarper
    Dec 4, 2012 at 2:05

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.