2

I need to move a couple of frame protectors from the head tube of my bike but don't want to damage the paint in removing them. What's the best way of getting these off?

  • 1
    steam? You could see if a boiling kettle helps. Whatever else, it'll be pretty harmless – PeteH Jul 15 '14 at 6:21
6

It depends on the type of adhesive. Sometimes it can be just pulled off. Sometimes the gentle heat of a hairdryer (not a heat gun) can weaken an adhesive and make it easier to remove.

Or you can try the use of GooGone or similar adhesive thinner/solvent (try on an inconspicuous place first to make sure it won't damage the finish).

Heat and solvent cover 90% of cases.

If the protector was epoxied on, then it is very hard to take off without damaging the finish.

  • If you can get the frame protector off olive oil is generally a very good adhesive remover. – DWGKNZ Jul 15 '14 at 0:33
  • So is WD40, TriFlow, or any light oil. – RoboKaren Jul 15 '14 at 1:04
  • 1
    You don't put it directly on the protection. You try to peel up a corner and dab a bit in to weaken the adhesive, then keep on working it. (And the reason GooGone is used as paint prep is that as a strong cleanser it will remove all trace of oils and other contaminants from a surface. It can also damage some paints, so needs to be used with care -- as I specified in my answer). – RoboKaren Jul 15 '14 at 2:53
  • Have you even used the stuff? You might want to read the FAQ here: googone.com/FAQs.aspx – RoboKaren Jul 15 '14 at 3:08
  • 1
    See also the response here (bicycles.stackexchange.com/questions/5636/…) where Surly - the bike manufacturer - specifically recommends using adhesive remover (aka googone). – RoboKaren Jul 15 '14 at 5:17

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.