I purchased an Aosom trailer a while back, and the wheels and tires are truly horrible.

Aosom Elite II bike trailer

So much so I only run light loads now.

I'm looking for 20" wheels that are either double wall alloy or vintage steel wheels.

I'm leaning towards used vintage wheels because they are cheaper.

My main problem is finding wheels that will fit on the trailer. All wheels that I see already contain a real axle. How do I remove the rear axle from the wheel?

Here are some images of the wheel and axleThe axle assembly is held together by small c clips and retainers

bearing and axle removed

  • Is this the Aosom wanderer trailer? I have one of them and swapped the wheels. All I did was file the drops to accommodate standard axles.
    – BPugh
    Commented Sep 8, 2015 at 14:45
  • No, it's their 20" Large red trailer seen here. aosom.com/d-12/Aosom-Large-Bike-Bicycle-Cargo-Trailer-Red.html
    – iLearnSlow
    Commented Sep 8, 2015 at 15:14
  • Some photos of the problems would help. A picture of the wheel axles and such. Either way, I have the Wanderer that came with 16" wheels and the axles had a notch taken out of them so they was more narrow in diameter than standard. All I did was take a file to the drops so it would fit a standard diameter axle and use some 20" wheels that I had from another trailer. It is either do that and be done, or always worry about finding the right axle/hub combo.
    – BPugh
    Commented Sep 8, 2015 at 15:29
  • I've added some photos if that helps.
    – iLearnSlow
    Commented Sep 8, 2015 at 16:05
  • Totally different system than mine, I have standard fork-ish drops on mine.
    – BPugh
    Commented Sep 8, 2015 at 16:50

1 Answer 1


Those are standard folding wheelchair hubs (the wheelchairs fold, the wheels pop off easily), and they're really not designed to work in bike trailers. Folding chairs are typically used at low speed and for comparatively short distances. Despite the weight of wheelchair users, in practice those axles will bend on a bike trailer at much lower loads than you would expect because of the dynamic nature of the bike trailer. You just don't see people riding wheelchairs off curbs at 30kph, or through potholes at 50kph... both things commonly done with bike trailers. So be careful or expect the bend axles.

You should be able to find higher-quality wheelchair hubs, but I have no idea how or where. What I suggest is measuring the axle diameter because I suspect it will be 10mm, which is a standard bicycle size. If it is then you should be able to get any standard bicycle hub that uses cartridge bearings (like your current wheels do) and fit the axle you have into them. Test fitting should be straightforward, so I would take a wheel and axle with you when you visit bike shops.

Depending on how committed you are you could just rebuild the wheels with better rims and spokes, or you could replace the lightweight pop-off axles and wheels with something stronger. That might, however, just shift the point of failure into the frame of the trailer. So you'll need to think about how strong the trailer and hitch is, and whether bending the axles really is a problem for you.

In my case I looked at those axles, thought "that's really cool", read up one other people's experiences, and decided not to go down that route. My current trailer has a 20mm through axle that runs right across the frame, but I also carry more than 100kg in it on a regular basis.

Not the answer you're looking for? Browse other questions tagged or ask your own question.