1

I had to patch a flat yesterday and now my quick release won´t tighten up anymore. It makes a ratchet Sound when I turn it trying to tighten it. I remember it was hard to loosen the quick release when I removed the wheel yesterday. Any ideas?

The quick release is in pretty pristine condition so I thought I would ask advice before replacing it outright.

Improve this question
5
  • What happens when you remove skewer and try to tighten nut on the other end of skewer? Did you check thread, maybe it is striped? Is QR lever moving properly?
    – False Identity
    Commented Oct 31, 2016 at 10:21
  • I can´t remove the nut on the end of the skewer for some reason. It doesn´t screw in either direction but makes a strange ratcheting noise. The QR Lever works fine.
    – Mike
    Commented Oct 31, 2016 at 10:47
  • Sounds like the threads on that one end have become stripped or severely cross threaded
    – Nate W
    Commented Oct 31, 2016 at 14:54
  • 1
    How are you tightening the QR? The word "turning" makes me wonder if you're using it right. The QR lever should be in the Open position while you tighten the nuts by hand, and the flip the QR lever so it clamps up. I've seen QR levers used like folding wing-nuts and that's not right.
    – Criggie ♦
    Commented Oct 31, 2016 at 21:31
  • @Criggie: That's the reason for 'lawyer lips' on front forks, too many people don't know how to operate QRs. ;-)
    – Carel
    Commented Nov 1, 2016 at 17:02

1 Answer 1

Reset to default
4

Sounds like the thread of your skewer and/or the end nut is stripped ... as an emergency measure you could try inserting a slotted washer (see below) under the nut so that the QR can be tightened again, but for a proper repair, you'll need to get a replacement skewer.

enter image description here

Improve this answer
0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.