1

My bike is Giant Defy 5 and trainer is Elite Rampa. I notice that after putting my bike on the trainer and riding for a while, the rear wheel tilts to one side, usually resulting in the wheel rubs the brake and even frame. I do not have this problem outside. Is there something wrong with my trainer setup? Thanks a lot for your help!

3
  • 1
    Do you have to replace your standard quick-release and use a trainer specific quick-release? A tilting wheel indicates that the QR isn't tight enough. Tighten the right nut by 1/8 to 1/4 of a turn.
    – Carel
    Commented May 25, 2017 at 15:39
  • 1
    Yes. I already use the skewer comes with the trainer. I will try to tighten it a little more. The right nut is the driver side? Thanks.
    – tonyhhkung
    Commented May 25, 2017 at 15:51
  • 1
    Yes, opposite the cam/lever of the QR. You open the lever tighten the nut slightly and close the lever again. Basically the same you'd do if you put in a wheel.
    – Carel
    Commented May 25, 2017 at 15:54

1 Answer 1

1

I can't think of any reason that would be migrating in the frame unless it wasn't secured enough to begin with. You should check the tightness of your quick release.

1

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.