7

I have a Schwinn floor air pump and its nozzle is the kind you push down and flip up the lever to connect. With a brand new inner tube installed I could not get it to connect with the valve as I have rims with a deep section, with these particular rims even inflated you only have the brass end of the valve showing.

Is there an easy way to inflate the tire with this set up?

enter image description here enter image description here

  • Did you partially inflate the tube before mounting the tyre? – David Richerby Feb 14 '18 at 20:36
21

The real answer is you need inner tubes with longer valve stems. Tubes come with various length stems to accommodate deep section rims.

There are screw-on valve stem extenders available for both Presta and Schrader that you could use to extend your stems. (I think some Schrader ones are actually for car tires, but they would still work for a bike.)

With out an valve extension, to get started, try pressing down hard on the tire and tube where the valve stem is to press the it out of the rim so you can get the pump nozzle attached. Having someone to help you will make this easier. You can also thread a valve stem nut onto the stem to retain the stem when you try to get the nozzle on.

Another approach to getting started, before getting the second tire bead onto the rim, reach inside the tire, press the valve stem out of the rim, clip on the pump, then fit the second tire bead.

  • 2
    Concur. OP can also push fingers directly into the tread by the valve stem, to push as much valve out as possible. That may be enough to let nozzle get an airtight grip on the threads. – Criggie Feb 14 '18 at 23:36
1

Well, it seems that your pump has both connectors: the car one and the Presta one. (Sorry, I'm not sure about the terminology in English, in Czech they are "auto" and "velo".)

The trick is to get this little gadget which is screwed on top of the valve and then the pump is connected. Now, as the gadget is wider than the valve, it prevents the valve from slipping into the rim. I found it on Amazon under the name Bike Adapter for Air Compressor. However, here even some bike shops sell them. Just be sure you get the correct thing!

  • 1
    There are common adapters for Presta (your "velo") to Schrader/car/auto valve size, but not so much the other way around. – Criggie Feb 15 '18 at 10:35
  • 1
    @Criggie I know, this is less common, but very useful. I saw both actually, and the one I have is perfect (I'll post a photo of the one I have once I get home). And thanks for the terminology, I'll correct it in the answer! – yo' Feb 15 '18 at 10:37
1

One trick I've used for wily valve stems is to use my thumb or a broomstick on the floor or some such object to push the stem as far out of the hole as it will go.

  • 1
    The broom handle is a nice trick! – David Richerby Feb 19 '18 at 8:23
0

The valve stem may simply not be long enough. Try, as previously suggested above, press on the tread directly opposite the valve in order to push the valve farther through the rim. Hold it in place while connecting the pump. The better solution, again, as mentioned above, is to replace the tube with one having a longer valve stem. If you do this, you may want to consider switching to a tube with a presta valve (you would also need a small adapter for the rim hole, available at bike shop, because the presta valve is smaller in diameter). Presta valves have a nut that tightens against the rim to prevent the valve stem from retreating into the rim.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.