4

I just got a Garmin Edge 1030, and have newer Ultegra Di2 with the buttons on the hoods. I was excited to see that the Garmin can connect to Di2. When I look for it in the sensors, it is not coming up. Do I need to add an ANT+ transmitter to my current Di2 setup? I am not sure, or is that something that should already be installed and the problem is else where?

4
  • 1
    You'll need the Di2 transmitter installed and most certainly an update for the Di2 firmware as well.
    – Carel
    Sep 16, 2018 at 7:26
  • 2
    You need this transmitter: EW-WU111 Di2 ANT+ but you must have either the BT-DN110 or the BM-DN100 battery in the system.
    – Carel
    Sep 16, 2018 at 7:47
  • Is the transmitter typically an add on, and not something that comes standard? I have a Trek Emonda SL7. There is not much detail on the Di2 trekbikes.com/us/en_US/bikes/road-bikes/performance-road/… Sep 16, 2018 at 18:13
  • 1
    Unless stated otherwise in the specifications of said bike, the transmitter is typically an add-on. If it is installed on your bike it should show up under 'sensors' as 'DI2' on your head-unit if Di2 isn't in sleep mode, meaning a button has been touched recently. Note: If you buy a transmitter you'll also need a short length of e-tube wire.
    – Carel
    Sep 17, 2018 at 7:37

1 Answer 1

3

You need to install a D-Fly unit. Probably this one: EW-WU111 Being able to use the Garmin in rain and cold weather with gloves is brilliant. However check if you have the right components: these batteries are ok: BT-DN110 / BM-DN100

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.