Rather than replace the stem on every rusty bike I come across, I want to replace some stem bolts which are rusted, cheap original ones. I know they can differ in size a bit so I would get some that fit nicely the profile of the existing stem.

Are there any specific requirements for bolts to do this job? Can I just bulk buy some stainless steel socket head cap screws?

In particular this is for other people's bikes, or refurbishing ones to be sold. I would maybe try things out on my own bike but don't want to take any risk with someone else's.

Most jobs on the bike I would be more confident about subbing bolts in, or they usually have better lasting bolts, but stem bolts seem really safety critical to me but often rust and deserve replacing. Am I worrying where there is no need?

enter image description here

  • 1
    The top bolt is not critical at all because it is only used for setting the free play of the head-set and doesn't bear any load after that. The pinch bolts are normally tightened to a max of 3-5Nm, same for those holding the bar. Quality stainless bolts will perfectly do the job. Quality stems use stainless bolts btw. – Carel Apr 10 '20 at 9:10
  • @Carel aye, pinch bolts and plate bolts are the issue. Prompts the question, how do we judge quality of bolt? Maybe that is the question – Swifty Apr 10 '20 at 9:30
  • 2
    I've prettified bolts like this, by soaking in rust converter, a brief touchup with sandpaper, and then a light spray of black rust blocker paint. Let the paint harden for a couple days before refitting to prevent damage. Apparently "evaporust" does similar but I've not used it - I used a phosphoric-based converter that changes brown rust into black phosphoric oxide which doesn't progress. – Criggie Apr 10 '20 at 11:46
  • @swifty :Stainless steel is more tension resistant than standard (8.8) steel that is normally used for bolts. – Carel Apr 10 '20 at 17:54
  • 1
    It's a good question. There probably is a right technical answer out there in terms of what performs best in ultimate terms. In BMX land I know at least some stems come with grade 8 socket cap screws, which while not stainless are pretty corrosion resistant in their black oxide coated form, and hardware stores tend to always have them, so that's one thing I think you can grab and feel good about using. – Nathan Knutson Apr 11 '20 at 2:27

Most bolts should have their tensile range marked on them somewhere, often stamped inside the hex cap. There should be a short number - 3.6, 8.8 etc.. Even a fastening rated as low as 3.6 is capable of 27 tons per square inch, more than 300n per square meter. A stainless steel M6 can probably handle 1.25 tonnes, the aluminium you're bolting into / through will fail before that.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.