i was wondering if anyone has an idea of what my issue is exactly and how i can fix it

the gears are super difficult to switch, 6 to 5 is difficult but still doable and going from 5 to 1 is just not happening, however when it comes to going in the other direction the lightest touch will make it go from 1 to 6

any idea how i could fix this?

  • 1
    how old is the bike, and when did it last have new cables installed?
    – Swifty
    Jun 1, 2020 at 20:17
  • You could try to Lube the cables.
    – mattnz
    Jun 1, 2020 at 20:19

1 Answer 1


This is almost always caused by friction coming from the cable housings. The reason is that in one direction the shifter is pulling the cable through the housing and must overcome any friction, which could be caused by contamination, corrosion, tight angles, and/or fraying. In the other direction it's releasing cable and does not have these forces to overcome.

You can test whether this is the case. On most bikes this is done by shifting into the lowest gear, then, while not riding or turning the cranks, shift the right shifter into the highest position. This creates slack in the rear derailleur cable. Grab the rear housing loop and pull it out of the housing stop on the chainstay. Do the same with any other housing stops you can. Then try working the shifter back and forth to see whether the friction is gone. While you're doing this you can do a simple clean and lube of the cable, which there are many guides to here, and depending on the cable layout you may be able to visually inspect for issues. Afterwards you can use the above steps in reverse to put it back together.

If the test revealed the problem to be cable friction, but cleaning and lubrication doesn't fix it, replacing the cable and housing is needed.

  • Concur - OP should start by isolating the derailleur from the cables from the shifter, which is easy if there's exposed inner cable, just pull them to see how the downstream parts work.
    – Criggie
    Jun 2, 2020 at 1:15

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.