6

Looking for some advice on what tool I need/the process to remove the pivot bearings from the Shimano Ultegra direct mount rim brakes. It looks like I'll need a hook wrench(?) to get at the rear silver nuts, but the black notched ring on the front I'm unsure of .

Note this is not a question of how to remove the caliper from the frame - I want to remove the sleeve that the silver bolt sits inside.

Reason for asking is one side feels gritty and a little tight.

EDIT: I suspect this answers my question: https://si.shimano.com/pdfs/ev/EV-BR-R8010-RS-4254.pdf

The parts I'm referring to are not explicitly listed so I doubt are meant to be serviced.

front view

side view

4
  • I don't know - would a cone spanner help ?
    – Criggie
    Oct 3 '20 at 23:47
  • 1
    This is a guess but it looks suspiciously like it takes TL-ST01. They're only a few dollars. Oct 4 '20 at 4:12
  • 1
    @Criggie unfortunately there are no flat sides to lock onto - I tried a set of needle nose pliers and an some mole grips but wasn't having any luck. Oct 4 '20 at 11:15
  • @NathanKnutson never even heard of that tool before but it looks promising, and is cheap enough to be worth a shot. Now to find one. Oct 4 '20 at 11:16
1

I would probably leave them alone unless you have a lot of confidence in yourself as a mechanic. Those are the brake posts that are pressed (not threaded) in at the factory, and serve as the brake mounting posts (since the frame doesn't have posts).

If you must disassemble these, you can watch a video of someone with very shaky hands pulling a slightly earlier generation of direct mount brake apart here:

Shimano Direct Mount Rear Brake Repair and Mods Tutorial Guide How To DIY

You'll have to make a couple of tools yourself, and if you're lucky, you won't scratch up the caliper or accidentally break any of the parts. The caliper posts aren't sealed at all, so if this is a chainstay-mounted break, it's likely that a bunch of grit got in there and is making the post/brake body interface gritty.

This newer generation of brake may also be flange-riveted at the back of the brake body, meaning it's a one-way fit; once disassembled, it will not fit back together properly at all.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.