I checked my bike for play yesterday and found some in the headset when rocking while slamming the front brake. I loosened the stem bolts and top cap then tightened them again. The play in the headset is gone. I just checked the play in the spacers for my own curiosity. I see that that the spacers below the stem have no play, cannot even rotate. The spacer above the stem can rotate quite freely but has no sliding freedom. Does it need more tightening in the top cap? By the way, I do not have a torque wrench, I am tightening by feel and check.

enter image description here

1 Answer 1


When the stem is clamped in place, it's enough to keep the headset in place.

The top cap is used only for adjusting headset bearing preload and keeping water and dirt out of steerer tube, so in principle you could even remove it after tightening stem bolts and save a few grams of weight. You could as well tighten it without interfering with headset adjustment if you like.

  • 5
    If the top cap won't hold the spacer even after tightening, OP might need a thicker spacer, or a shim added to the stackup.
    – Criggie
    Aug 30, 2021 at 13:25
  • 6
    If the top cap won't hold the spacer after tightening, I wonder how they managed to set the preload so that the spacers below don't move.
    – ojs
    Aug 30, 2021 at 14:37
  • @ojs thanks for the detailed explanation. I took the bike on a ride today and it felt really good. I purposely grabbed the handlebars firmly when climbing and accelerating, and they felt very safe. Aug 30, 2021 at 23:11

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.