Skip to main content

All Questions

Tagged with
Filter by
Sorted by
Tagged with
1 vote
1 answer
478 views

Rear derailleur catches and springs towards front of bike when in predominately in the smallest front chainring

I have a Planet X EC-130 carbon road bike with Ultegra group set. I have the stated problem above; it mainly happens while in the smallest chainring and does it at all speeds. It sometimes goes 20 ...
Neily H 's user avatar
6 votes
2 answers
3k views

What can cause the chain to stay attached to chain-ring at bottom causing it to ride up and jam in the frame ("chainsuck")?

I'm looking for possible/likely causes of an issue with my front chain-rings on my bike. It's a 3x8 setup and the problem is worst on the smallest front chain-ring, and worse again when combining ...
kabdulla's user avatar
  • 375
4 votes
1 answer
231 views

What is the best way to increase gear inches on an old bike?

I only recently got into bicycling and without knowing anything, I bought a bike from a local used bike distributor. Here's what I've learned about the bike. The frame, seat, and handles are original ...
Nathan Roberts's user avatar
0 votes
1 answer
212 views

Is my bike safe to use if cogs and crank is not that aligned?

Hey guys is it fine if my freewheel bike which is single speed is not that straight with its chain line, because my cogs and crank arent that straight but it is also not that far, im thinking if it is ...
Jebs Jebs Santillan's user avatar
4 votes
2 answers
2k views

Chain hitting front derailleur cage with H limit screw fully loosened

I followed the Park Tools guide to set up my gears. The rear derailleur was a success but I can't manage to adjust the front derailleur so that the chain stops grinding on the guard. There's no more ...
Luke Allison's user avatar
9 votes
5 answers
2k views

I failed to replace my chain at the proper interval. Will I have to replace my whole drivetrain?

My bicycle is a 2012 Specialized Secteur. It has 6000 miles (10000 km), and I have never replaced the chain. I recently began noticing that the chain always seems out of alignment with the rear ...
Carlo David's user avatar
4 votes
2 answers
3k views

Rear derailleur max capacity exceeded?

My MTB is a Lapierre X-Flow 512 2012. It has a Shimano RD-M980-SGS 10v rear derailleur which has a total capacity of 41t (see official specs). But it comes with a 11-36 cassette and a 24-42 crankset (...
Gabriel Hautclocq's user avatar
1 vote
1 answer
101 views

Bicycle buying suggestions please! [closed]

As of yet, like most other Indians, I've only ridden a single speed, which was brought for 4000 rupees, about 13 years ago.. Yes, it's still in use! My budget now is strictly 13000 INR for the bicycle ...
Gaurav's user avatar
  • 11
0 votes
1 answer
514 views

Shimano FC-5700 chainring with FD-5600 derailleur?

Currently my front chainrings are Shimano FC-5600 48/40 with FD-5600 derailleur. As I can not get new chainrings in FC-5600 I was asking myself if my FD-5600 supports FC-5700 53/39 chainrings?
Jaleks's user avatar
  • 103
2 votes
1 answer
3k views

Shimano Tiagra - Install smaller front chainring

I recently bought a used Trek Checkpoint ALR4, with which I'm very satisfied. The gearing is ok so far for going on plane ground an light uphills, but when going on long and steeper hills it gets ...
Gistiv's user avatar
  • 303
2 votes
1 answer
2k views

How do I figure out what crankset replacement will fit my derailleur?

I have a bike with a Shimano FC-M560 crankset in the front which I want to replace. I naively bought a Shimano FC-TY301 crankset, thinking that there's norms and that 3-speed cranksets are more or ...
oarfish's user avatar
  • 415
7 votes
3 answers
3k views

Can I use a narrowide chainring on a double rings crankset?

I would like to go touring using my narrowide chainring, but I would like as well to put a smaller chainring (the infamous Grannie) so that I could have it as a last resort in case of really hard ...
Paolo Goatspeed's user avatar
3 votes
2 answers
140 views

Replaced chain, now the chain falls onto the small chaining

I rode for a little while longer then I should have with my old chain, so I replaced the old chain and cassette. But now when I ride in the big ring, the drivetrain makes a horrible sound and the ...
Chris's user avatar
  • 31
0 votes
1 answer
70 views

SOMEONE HELP PLEASE:( [closed]

I'm getting a new bike and i'm wondering if a Shimano TX50 front derailleur is good enough and will do the job or should I get another bike which has an acera, FD-M390 front derailleur. Thanks in ...
user29976's user avatar
1 vote
3 answers
5k views

Can I ride a triple front chainring with no front deraileruer

I've managed to strip the threads on my front deraileruer mechanism. Its off the bike now - can I ride it as-is until I locate a new front mechanism? The chain does stay on the front chainring where ...
Criggie's user avatar
  • 131k
3 votes
1 answer
985 views

Shimano Sora 3500 (3x9) and Alivio front derailleur

Please help rebuild my bike :) I have Scott Sub 30 2011 http://www.evanscycles.com/products/scott/sub-30-2011-hybrid-bike-ec025449 and right now I would like to change shifters to Shimano Sora 3500 (...
Agressiva's user avatar
1 vote
2 answers
2k views

How to change 2x11 to 3x11 on mtb

Hey I was wondering how you would change a chainset from 2x11 to 3x11 on a Carrera Fury (SRAM components) Thanks
Sancho Jr's user avatar
2 votes
1 answer
4k views

Front shifter has three positions, but front chainring is only double. Is this a problem?

My Merida Cyclocross 3 bike has a double chainring at the front. After a few weeks of being a little annoyed about the awkward shifting when going up steep hills, I realized that the front shifter and ...
Victor Sand's user avatar
1 vote
2 answers
1k views

Chain Slip at front changing from large to small front chain wheel (with large cog at back)

I have a Pinnacle Neon 3 Hybrid, Shimano Sora 9 speed cassette and 2 chainrings at the front. The bike is 2 weeks old and I've cycled around 65 miles so far. Chain ring has come off 3 times at the ...
mcon's user avatar
  • 11
0 votes
1 answer
3k views

What does the chainring have to do with SRAM YAW

I'm shopping for 110 BCD chain rings and I noticed that some of the SRAM ones are labeled "YAW FD only". As far as I can tell the derailleur doesn't touch the chainring so whats so special? Can I ...
user1816847's user avatar
1 vote
3 answers
7k views

Can I replace the front front derailleur with chain guide?

My front derailleur (Shimano LX T670 / 34.9mm) has been stuck on the highest gear for a couple of weeks now which has got me thinking about how little I use it. To save weight could I replace my front ...
ADarkDivideGem's user avatar
3 votes
1 answer
166 views

Will I snap my derailleur? (too large front chainwheel)

I have an old racer (1994 Specialized Epic Allez - lugged carbon) that's in pretty good shape. I brought it to an LBS that's got a pretty good reputation and that I've used before, to change the chain ...
Popup's user avatar
  • 639
2 votes
1 answer
1k views

Need help choosing compatible rear derailleur, cassette & chain

I just "inherited" a bike that has no rear derailleur or chain. It also looks like the cassette is pretty worn, so I'm thinking about replacing that too. I've looked around on the forum and I think ...
Jay Rennicks's user avatar
3 votes
2 answers
1k views

Biopace chain rings and front deraileur rub

Turns out my front chain rings are biopace, after I thought they had disappeared! I've got a problem with the chain rubbing the front deraileur at a certain point every rotation. I only get this in ...
will's user avatar
  • 924