Questions tagged [derailleur-rear]

Questions referring to the derailluer responsible for moving the chain along the cassette

20 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
6
votes
0answers
139 views

My derailleur completely “opened” up. It is now almost a straight line. What have i done to my derailleur?

I had a flat on the side of the road. So I took my wheel off to replace the tire with a temp to get me home. When I reinstalled the wheel, the derailleur "opened up" completely...what have ...
4
votes
0answers
77 views

Pulley alignment of Shimano derailleur

I noticed a misalignment between the two pulleys on a brand new Ultegra R8000 derailleur. It's less convincing on the photo than in real life, but still very much visible. I came across this ...
2
votes
1answer
56 views

Chain alignment on jockey wheel

Going over the lower jockey wheel (see first picture), my chain rubs against the inboard side of the cage and sometimes snags. It is a brand new derailleur (Shimano Acera M360) and a new derailleur ...
2
votes
0answers
461 views

Why do SRAM rear derailleur not have a parallel movement

My SRAM rear derailleur (Rival 22 circa 2016) has a non parallel movement. When it is in the lowest gear, the cage and pulley sprockets align with the cassette sprockets, but when it's in the highest ...
1
vote
1answer
31 views

Mix Match Using Wolftooth Tanpan

My current setup are using a full Shimano 105, medium cage GS 11-34t, crank are 50-34t. Through some digging, I want to upgrade the RD using Deore XT M8000 SGS Long, paired using wolftooth tanpan. ...
1
vote
0answers
31 views

Derailleur can't shift to 51-T sprocket. Deore CS-M5100 + RD-M5100

ISSUE: When attempting to shift to the largest cassette sprocket, the side of the derailleur cage contacts the 51t sprocket, so the chain is not able to go up the gear. WHAT I DID: My drivetrain was ...
1
vote
0answers
47 views

Using 11-36t 9 speed derailleur with 11-40t 9 speed cassette

So I've got the shimano altus rd-m2000 and it says that it only supports 11-36t. However, I've seen people on forums say that it's possible with this derailleur. Even it I was wondering if with a ...
1
vote
0answers
63 views

Direct mount rear derailleur

I'm upgrading an old MTB for commuting, it had a 5 speed on the back but I'm going to be putting on a new 26" rear wheel with a 7 speed cassette because the freewheel axle wobbles, makes noises ...
1
vote
0answers
39 views

Campagnolo rear mech screw type

My limit screws' heads have gone rusty, I want to replace them for looks and to make sure they are easy to adjust on a ride. I would love hex rather than Philips heads! Does anyone know the type of ...
1
vote
0answers
247 views

What is the thread size/measurement of the derailleur barrel adjuster?

The barrel adjuster threads on my commuter bike's RD have been marred when the barrel adjuster got bludgeoned on a side crash and I want to chase the threads before screwing in the replacement barrel ...
1
vote
0answers
190 views

Can't get in first gear on Shimano ten speed block

Just replaced drive chain on mtb ... new cassette (Shimano 10 sp ) new chain (Shimano 10sp) new rear mech (Shimano 10sp long) and new (Shimano 10sp). I've set bottom stop tensioned cable and adjusted ...
1
vote
0answers
319 views

SRAM eTap rear derailleur chain drop issue

I’m having an issue with my chain falling off the lower pulley wheel when (1) I hit a significant bump or (2) shift from large ring to small ring. But only in cogs 6, 7, 8. Any suggestions? I’ve ...
1
vote
1answer
67 views

Compatibility question

I was wondering on a mountain bike what rear derailleurs work if have a 21 speed bike. Additional information: 7 ring rear cassette and 3 in the front Will an 8 and 9 speed rear derailleur work or ...
0
votes
0answers
33 views

Bracket axle for Shimano RD-2300 rear derailleur

Where can I find a bracket axle for Shimano RD-2300 rear derailleur? I searched everywhere and I didn't find one. I need to mention that the frame type is Speed Fitness Alloy and bike is a Focus ...
0
votes
0answers
56 views

Rear derailleur adjustment

I have a 7 speed Shimano derailleur. It shifts really good from 1 to 6 but when I try to shift from 6 to 7 it just doesn't want to shift. Can someone help me?
0
votes
0answers
23 views

Shimano mechanical vs Di2 bracket axle unit difference

This puzzled me for a while, but I couldn't find an answer. Why are some mechanical and Di2 bracket axle units different? The interface on the RD body is the same, you can mount both to the same ...
0
votes
0answers
48 views

What might be causing the faulty shifting on my bike?

I bought a used bike that has 8 speed cogs and 3 speed chainrings. The front shifts great but the back regularly fails on the 6th and 5th speeds. I know a bit about adjusting the shifters so I can say ...
0
votes
1answer
112 views

Why does my Shimano Deore SLX dérailleur not rotate into the expected (vertical) position?

I have a Scott E-Genius 730 Plus mountain bike (around three years old). I had a chain snap recently, so I have replaced the rear 10-speed cassette, and am now trying to route a new chain correctly. I ...
0
votes
0answers
31 views

Rear derailleur not shifting first time from lowest gear

I am installing new cables and trying to reconnect the rear derailleur. I can the gears indexed perfectly on the way up but when I try to shift down from the lowest gear (biggest cog) it doesn’t move ...
-1
votes
1answer
445 views

Rear derailleur is not working correctly

Having problems with the derailleur in an old Panasonic 10 speed. When I shift the bike all the way up to 5th gear ( smallest in the back) the spring on the hanger of the derailleur has no tension at ...