Questions tagged [magura]
The magura tag has no usage guidance.
9
questions
2
votes
1
answer
49
views
Shigura - Can i use a Shimano XT Lever on A Magura HS33 Hydraulic Rim Brakes
Good day to Everyone,
My Magura HS33 Lever on my ZHI Z3R trials bike broke, and i was wondering if i could replace it with a Shimano Deore XT BL-M775, as i have it stocked on my parts bin.
And if i ...
- 121k
2
votes
1
answer
514
views
Bleed port diameter on Magura HS 11 rim brakes?
Although the bike is barely six months old and the brake pads are very far from worn, I find the HS11 brakes a bit soft/spongy: I like the brakes to work with a short run.
Tightening the adjustment ...
3
votes
1
answer
341
views
Magura brake pad change: friction noise?
After replacing my worn-out Magura brake pads (MT4 brakes, 7P brake pads), I now have a continous light friction noise when the wheel is spinning (front wheel).
The brake disc is brand new as well. ...
- 81.9k
3
votes
1
answer
400
views
Atomized bubbles while following Park process to bleed Magura MT5
I have the Park tool mineral oil bleeding kit (BKM-1), and followed their instructions for bleeding my MT5 calipers.
I ended up with soft/useless brake caliper. I think maybe I introduced air into ...
- 14.4k
3
votes
2
answers
819
views
Immense difficulties bleeding a shigura setup
I set up a shigura system with BL-M8000 levers, MT5 and MT4 Callipers and Magura hoses and shimano parts on the lever end. But I couldn't get even a decent bleed on them. I tried a couple of ...
- 203
1
vote
0
answers
357
views
Magura mt5- non stop micro bubbles coming out while bleeding
I have a problem bleeding my Magura MT5 brakes.
I used two 50-ml syringes and the EZ MTB bleed kit. I pushed fluid from the syringe attached to the caliper to the top (at the lever) and back again.
I ...
- 11
2
votes
1
answer
757
views
Removing Magura HS11 rim brake (hydraulic) without quick release lever
My previous Magura HS11 hydraulic rim brakes had q/r levers, but my latest (s/h) Gazelle does not.
Which bolt do I remove to remove the brake from the fork to remove/replace the wheel and/or the brake ...
- 121k
0
votes
1
answer
315
views
Hydraulic rim brake with racing bike levers
I came across the picture below which claims to show racing bike levers of a Magura hydraulic rim brake (source). According to the source website the displayed break levers belong to Magura HS77. I ...
- 4,170
1
vote
0
answers
74
views
Are Magura HS33e levers compatible with HS22 brakes?
I plan to convert a bike with Magura HS22 hydraulic brakes to electric. Thus I would like to replace the brake lever by one having the controller output to stop the motor while braking.
From my ...
- 121k