Questions tagged [rear-wheel]

The aft wheel(s) of a bicycle or tricycle. In most bicycle designs, the rear wheel is the drive wheel but this is not always the case especially with recumbents and tricycles.

7 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
152 views

Do I need to remove this DT Swiss ring nut? (360 hub)

I'm swapping bearings on Roval Traverse rear hub, which is said to have DT Swiss 360 internals, 3-pawl. Do I therefore need to remove the ring nut as per normal DT Swiss instructions? If so I'll need ...
2
votes
0answers
61 views

What is the "nipple head height" of a DT Swiss Squorx nipple?

What is the nipple head height of a DT Swiss Squorx Nipple? I am building a wheel and to calculate the ERD, I must first figure out what the "nipple head height" is. The rim of choice is a ...
2
votes
0answers
80 views

Rear wheel not centred

I've been trying to fit a second rear wheel to a fracing frame rebuild and I've noticed it is very off-centre. You can see from the pictures that it is much closer to the non-drive side than drive ...
2
votes
0answers
40 views

Freehub with sealed/cartridge bearings

I decided to buy a new freehub and replace it myself, as the one I had broke down (started spinning to both sides). However, I didn't realize the new freehub has sealed/cartridge bearings as opposed ...
2
votes
0answers
807 views

Rear wheel rubbing frame

I notice when I tighten my quick release it centres but when I tighten the boot side it starts to get out of centre. Could it be my quick release??😬🙏🏼 I have a 2017 giant atx 2
0
votes
0answers
88 views

Rear wheel not centered

So i just noticed that my rear wheel is not centered. I think it has been like that since i sent my bike for a service 6 months ago. The wheel is brand new I also noticed a thing which looks like a ...
-1
votes
1answer
169 views

Back wheel cannot turn.

I have an ONYX ONE 29' cruiser bike. It's a really big bike and it has rear wheel brakes. I recently removed the back wheel with a power tool, for I tried to remove it with a wrench, and it wouldn't ...