I have a bike that was in a major front end collision (I T-boned a car). The frame is steel and the bike bent at the head tube, the welds seem to be fine. Pictures below.

I am fully aware the appropriate thing to do in this situation is never ride the bike again. However, I loved this bike, it was built by a very talented builder, and I would like to bend the head tube back and build it up as a townie, basically to cruise around to the bar and the corner store.

My plan is to put the head tube in a vice and use the frame as a lever to bend the head tube back. While I realize this is not something anyone should advise anyone to do, people used to straighten our bent steel frames all the time.

My question is, is there a world where this ever goes well? Or is this absolutely too far gone?