7

It looks to me like you may be able to use a clamp-on cable stop. All you need is a round steel-alloy frame tube that is strong enough to accept a clamp. If the clamp is located close to the point where the tube joins the bottom bracket, the frame tubing should be plenty thick enough. (I am not an engineer, and if you have doubts, especially where a frame ...


4

That is surprising. I wondered for a moment if they only intend you to run it 1×, but I can see on the All-City website that they show it set up 2×. My first thought was to get a clamp-on stop, as Ichabod suggests. However, there are some front mechs that have integrated cable stops, so see if one of those would work for you.


4

I believe the part you require is shown here: https://www.ison-distribution.com/english/product.php?part=BBPSG7600 It is available from all Surly/All-City/Problem-Solvers dealers. Single-sided, bottom bracket mounted cable guide, with integrated cable housing stop. Intended to fit 40mm diameter bottom bracket shells Includes M5 mounting bolt Direct ...


3

Not quite your situation, but I 3D printed some cable retainers with a curved back-side to match my tube profile, and epoxied these on. https://www.tinkercad.com/things/56fo0JH2oJF-epoxy-on-zip-tie-mount-for-53mm-tube-holding-7mm-cable This example would NOT work as an end stop, but it may be possible to make something that does that task. Separately, ...


Only top voted, non community-wiki answers of a minimum length are eligible