Learning is a mess
  • Member for 2 years, 6 months
  • Last seen this week
  • Between Good and Bad
3 answers
8 votes
2k views
What are the benefits of hand built wheels over automated ones?
1 answers
6 votes
560 views
Gear shifting is good enough after 6 years. Does that mean I don't need to replace my cables?
2 answers
6 votes
990 views
Post crash damage assessment: can I keep this carbon fork and this front wheel?
1 answers
4 votes
411 views
Road bike headset: the spacer above the stem can rotate but not the ones below, is it wrong?
2 answers
4 votes
343 views
How/where can I find replacements for these 'wheel bearing caps'?
1 answers
3 votes
193 views
Missing bolt in my brakes, how can I find a replacement?
2 answers
3 votes
166 views
Overtightned the rear derailleur cable clamp. It is now blocked
2 answers
3 votes
331 views
Fork seized to frame: can I just hammer it down now?
3 answers
2 votes
170 views
Front brake lacks 2mm in reach. Can it be ironed out?
1 answers
2 votes
241 views
Road rim bike brakes don't open when using the release
2 answers
2 votes
251 views
Shimano crankset is near end of life, can I use a Tiagra 4700 replacement?
0 answers
1 votes
54 views
Tektro rear brake does not stay closed
1 answers
1 votes
52 views
First time repairing a rear wheel hub, I am hearing bearing on bearing rattle/clicks when spinning
1 answers
1 votes
91 views
New DIY project: restoring this bike from the bins. How can I service this back wheel?
1 answers
0 votes
81 views
Cannot remove campagnolo zonda freehub
2 answers
0 votes
607 views
What type of bottom bracket is this (pictures)? What tools do I need to replace it?